S E T T I N G U P T H E U N I V E R S A L R E M O T E C O N T R O L
Programming the universal remote control
The universal remote control has four programmable source buttons (
and
). You can program these buttons to control your TV, cable/satellite box, DVD or
Blu-ray Disc™ player, game system, DVR or other auxiliary source by entering the code
for your source's brand. There may be several codes for your source. You may need to
perform this procedure multiple times to locate the correct code.
Locate the code
1. Power on your source.
2. Locate the code for your source's brand in the Universal Remote Control Setup
Guide (provided).
Enter the code
1. On the remote control, press and hold the appropriate source button (
or
) until all six source buttons glow, then release. For example, to program
your TV, press and hold
The appropriate source button continues to glow.
2. On the number keypad, enter the code for your source's brand and press
Test the code
1. Test the source for basic functions by following the instructions for your source:
• TV: press the channel buttons. Press
Press
and
• Cable/satellite box: press
Press
and
• DVD or Blu-ray Disc™ player: press
Press
and
• Game system: press
2. Based on your source's response to basic functions:
• Remote responds accurately: press
your settings.
• Remote does not respond or does not respond accurately:
– If your source button glows: press
and 2 in "Test the code." You may need to repeat this procedure 30 or more
times. If all six buttons blink three times, you have cycled through all codes for
your source.
– If your source button is off: your remote exited programming mode. Repeat
steps 1 and 2 in "Enter the code" and steps 1 and 2 in "Test the code."
Note: Your source may not be compatible with universal remote controls or may
not accept IR (infrared) signals. Refer to your source owner's guide for more
information.
2 2 - E N G L I S H
until all six source buttons glow, then release.
to navigate.
to navigate.
to navigate.
and
to navigate through your menu.
. The settings menu appears.
. The programming guide appears.
. The settings menu appears.
to exit programming and save
to move to the next code. Repeat steps 1
,
,
,
,
.
Печатать страницу