Bose 10.2 Stereo Everywhere Руководство по эксплуатации - Страница 7

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Акустическая система Bose 10.2 Stereo Everywhere. Bose 10.2 Stereo Everywhere 29 страниц. Commercial sound system
Также для Bose 10.2 Stereo Everywhere: Руководство пользователя (8 страниц)

Печатать страницу

DISASSEMBLY/ASSEMBLY PROCEDURES

Note: The following procedures are for the

transformered units only. The passive

versions do not have a tap selection switch,

transformer, or capacitor within the enclo-

sure.

5. Wiring-Well Cover:

(Transformer and Capacitor Access)

5.1 To remove the wiring-well cover

located in the back of the enclosure, use a

flat-blade screwdriver or a 1/4" socket to

loosen the two screws that hold the metal

cover in place.

5.2 Swing the cover free to gain access to

the transformer and capacitor.

6. Front plate removal

(Access to tap selection switch)

6.1 Using a flat-blade screwdriver or a 1/4"

socket, remove the two screws that hold

the plastic front plate in position.

6.2 Lift the plate out to gain access to the

tap selection switch and wiring.

102

Surface-Mount Loudspeaker

1. Grille Removal

1.1 To remove the grille, take a small

flat-blade screwdriver or scribe and grasp

the edge of the grille at one of the corners.

1.2 Gently work the grille out of the retain-

ing slot.

Note: There is no grille frame exposed.

You must grasp the grille on the metal

portion of the grille and not on the polysty-

rene, which is part of the speaker

enclosure.

2. Grille Replacement

2.1 To install the grille, first be sure that

the Bose

logo is facing the same way as

the print on the back of the enclosure.

2.2 Fit the grille to two adjacent corners of

the enclosure.

2.3 Gently apply pressure to the two

remaining corners to fit the grille into the

enclosure.

3. Driver Removal

3.1 Using a cross-head screwdriver,

remove the three screws that hold the

driver in place.

3.2 Carefully lift the driver out of the

enclosure and cut the wires as close

to the driver terminals as possible.

4. Driver Replacement

4.1 Strip the wires and connect them

to the replacement driver.

Note: Make certain that the red wire is

connected to the positive (+) terminal and

the black wire is connected to the

negative (-) terminal of the driver.

4.2 Align the driver and gasket to the

J-clips. Make sure the gasket is correctly

positioned behind the driver to provide an

airtight seal.

4.3 Secure the driver to the J-clips with

the three screws. Do not overtighten.

(See Figure 3)

Figure 3. 102 Surface-Mount Driver

Replacement