Bose Acoustimass 6 Series III Руководство пользователя - Страница 13

Просмотреть онлайн или скачать pdf Руководство пользователя для Акустическая система Bose Acoustimass 6 Series III. Bose Acoustimass 6 Series III 18 страниц. Home theater speaker sytem
Также для Bose Acoustimass 6 Series III: Руководство по быстрой настройке (1 страниц), Руководство пользователя (44 страниц), Руководство пользователя (16 страниц), Руководство пользователя (25 страниц), Руководство пользователя (23 страниц)

LFE

BASS

CAUTION: The Acoustimass

matic protection circuit, which guards against most kinds of damage from electrical stress or

overload. This circuit activates at high volume levels to reduce output, causing a slight

decrease in volume. This is normal operation and indicates that power input may be exceed-

ing safe levels. Sustained listening at these levels is not recommended.

The LFE level control on your powered Acoustimass module increases or decreases the rela-

tive level of low frequency effects on movie soundtracks. Use it to regulate the presence of

these underlying deep bass sounds. Use the "test tones" feature in your digital surround

sound receiver to match the volume levels for each of the cube speakers. Then use the LFE

control on the Acoustimass module to match the volume of the LFE channel to the cube

speaker channels.

This feature will allow you to fine-tune your system after you have placed the Acoustimass

module in your selected location. If the room sounds "thin" or lacks bass, turn the BASS con-

trol in a clockwise direction to increase the bass level of the module. If the room sounds

"boomy" or has too much bass, turn the knob in a counter-clockwise rotation to reduce the

bass level of the module. The factory or detent setting is appropriate for a majority of listening

situations.

Your Acoustimass 6 or Acoustimass 10 speakers are compatible with the output from digital

surround receivers. Integrated Signal Processing assures full bass reproduction for all chan-

nels regardless of receiver settings. However, the following table suggests a set of recom-

mended receiver settings. The cube speaker arrays should be set to LARGE in the receiver's

digital display menu. The LFE, or subwoofer, is set to ON. If applicable, the crossover value

should be set to the lowest number possible, typically 80 Hz.

Speaker

Receiver setting

Front left and right

LARGE

Front center

LARGE

Rear left and right

LARGE

LFE/Subwoofer

6 and Acoustimass 10 speaker systems incorporate an auto-

(low frequency effects)

Using your system