Bose Companion 3 Руководство пользователя - Страница 4
Просмотреть онлайн или скачать pdf Руководство пользователя для Акустическая система Bose Companion 3. Bose Companion 3 26 страниц. Multimedia speaker system
Также для Bose Companion 3: Руководство пользователя (40 страниц), Руководство пользователя (40 страниц), Руководство по эксплуатации (30 страниц)
Печатать страницу
18. Use Proper Power Sources - Plug the product into a
proper power source, as described in the operating
instructions or as marked on the product.
19. Avoid Power Lines - Use extreme care when install-
ing an outside antenna system to keep from touching
power lines or circuits, as contact with them may be
fatal. Do not install external antennas near overhead
power lines or other electric light or power circuits, nor
where an antenna can fall into such circuits or power
lines.
20. Ground All Outdoor Antennas - If an external
antenna or cable system is connected to this product,
be sure the antenna or cable system is grounded. This
will provide some protection against voltage surges
and built-up static charges.
Section 810 of the National Electrical Code ANSII
NFPA No. 70 provides information with respect to
proper grounding of the mast and supporting struc-
ture, grounding of the lead-in wire to an antenna dis-
charge unit, size of grounding conductors, location of
antenna-discharge unit, connection to grounding elec-
trodes, and requirements for the ground electrode.
Refer to the antenna grounding illustration on this
page.
2b
Antenna grounding
Example of antenna grounding as per National Electrical
Code, ANSI/NFPA 70.
1---<\>'''---
Antenna lead-in wire
Ground
clamp_~
....
*,
ff1_-+-
Antenna discharge unit
(NEC Section 810-20)
Grounding conductors
(NEG Section 810-21)
Ground clamps
Power service grounding electrode
system (NEG ART 250, Part H)
Note
to
CATV system installer
This reminder is provided to call the CATV system
installer's attention to Article 820-40 of the NEC (of USA)
that provides guidelines for proper grounding. In particular,
it specifies that the cable ground shall be connected to the
grounding system of the building, as close to the point of
cable entry as is practical.