3M SGLP200-CL-BP Руководство по установке - Страница 9
Просмотреть онлайн или скачать pdf Руководство по установке для Системы фильтрации воды 3M SGLP200-CL-BP. 3M SGLP200-CL-BP 17 страниц. Reverse osmosis filtration systems
Также для 3M SGLP200-CL-BP: Руководство по установке и эксплуатации (17 страниц)
Печатать страницу
WHEN: Yearly
TOOLS:
Piece of 3/8" tubing OR Bucket
Bicycle or tire pressure gauge
Bicycle tire pump
1. Drain water from the storage tank.
a. Shut off the inlet water supply by removing the pre-filter or water booster system if
applicable.
b. Make sure the tank shut-off valve located at the top of the water tank is open.
c. Attach a piece of tubing (not included) from the water sample valve to drain OR use
a bucket to catch water from the water sample valve.
d. Open the water sample valve and drain the tank until empty. Leave water sample
valve open.
2. Unscrew the cap on the side of the tank to expose the Schrader® Air Valve.
3. Using a standard bicycle or automobile tire pressure gauge that is capable of reading
pressure accurately from 0-10 psi. Connect the air pressure gauge to the Schrader Air
Valve on the water tank.
4. Read the tank's air pressure.
5. The air pressure should be between 8 and 10 psi.
6. If the air pressure is below 8 psi or above 10 psi complete the following steps.
a. Using a standard bicycle pump add or release air pressure in the tank.
b. Repeat Steps 4-5 until the pressure is 8-10 psi.
c. Make sure the blue cap is replaced on the air pressure port.
7. Close the water sample valve.
8. Turn on the inlet water valve and/or booster system (if applicable).
9. Allow 60 minutes for tank to fill before operating equipment.
CHECK TANK PRESSURE
8