3M G5 Руководство - Страница 4

Просмотреть онлайн или скачать pdf Руководство для Гарнитуры 3M G5. 3M G5 10 страниц. Drive-thru systems
Также для 3M G5: Краткое справочное руководство (2 страниц), Технический бюллетень (6 страниц), Технический бюллетень (2 страниц), Краткое руководство по эксплуатации (3 страниц), Технический бюллетень (12 страниц), Руководство (8 страниц)

2. Mount G5 Basestation to the wall

The G5 Basestation can be mounted in the same place as the current XT-1 Basestation.

You may use either the Top or Bottom two mounting screws of existing XT-1 Basestation to hold the G5 Basestation on the wall.

Which one you choose depends on

• Where the cut-out (in the wall) that feeds the cable, is located.

• There being sufficient cable length to terminate the Speaker, Microphone, Induction Loop and Timer (Greet Event) wires.

Once this is completed you will need to drill the remaining two holes to secure Venus basestation to the wall.

NOTE:

If the current cable lengths terminating on the XT-1 Basestation are not long enough to re-wire the G5 Basestation, you may have to pull

new cable

However, if you are short by a few inches, you may splice in sufficient length of wire from an another spool of 3M Cables.

Make sure the point where you connect the two wires (or splice) is properly insulated with Electrical Insulation Tape and/or securely held

with wire nuts. This ensures against any accidental grounding of the wires.