Bose FREESPACE BUSINESS Руководство по эксплуатации - Страница 10
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Медиаконвертер Bose FREESPACE BUSINESS. Bose FREESPACE BUSINESS 50 страниц.
Также для Bose FREESPACE BUSINESS: Руководство по эксплуатации (34 страниц)
Печатать страницу
6. High Frequency Equalization
High frequency equalization is achieved through four cascaded active EQ stages consisting of
U101, U102, U103 and U104. The purpose of equalization is two-fold. (1) It provides very sharp
low frequency roll-off below 180 Hz (the crossover frequency of the acoustics) to prevent
overload of the L/R speakers; and (2) It provides finely tailored correction in the L/R speaker
pass band so that overall frequency response of the system is correct.
7. Automatic Dynamic Loudness
®
In order to compensate for the ear's loss of bass response at low listening levels, a Bose
patented automatic loudness circuit is employed. This circuit automatically senses the volume
level of the incoming audio signal, and properly adjusts the amount of low frequency bass boost.
When the volume level is high, the frequency response of the circuit is flat. When the volume
level is decreased (at the customer's audio source or through the electronic volume control),
the low frequency gain is increased in the region between 50 and 150 Hz.
Circuit operation is as follows: After passing through the Tone Control PCB, audio at U201 and
U202 (pin 7) is summed by resistors R101 and R131. The AC signal at pin 5 of level detect op-
amp U203 is negative -peak detected, and is presented across emitter resistor R236. The peak
detected signal has a 4 second hold time, and a 4 sec / 10 dB release time constant which is
developed within the feedback loop of U203 (pins 5,6 and 7). The voltage across R236 is
converted to a current source through transistor Q203, and flows into pin 5 of transconductance
amp U206. U206 and U207 (pins 1,2 and 3) form a variable gain stage (delta-G). Action is
such that increased current into pin 5 of U206 causes gain of the stage to decrease.
The variable gain stage is followed by a 55 Hz, Q=2.3 band pass filter (U207 pins 5,6 and 7).
The output of this stage is summed through resistor R247 with the flat response signal present
at resistor R248. This creates a composite frequency response curve with varying levels of 55
Hz boost. The overall desired loudness contour response is visible at U208 pin 1.
8. Low Frequency Equalization
A single stage Sallen-Key 2nd order high-pass / low pass network (U208 pins 5,6 and 7)
provides bass channel equalization and low frequency roll-off to prevent subsonic low
frequency overload.
9. Power Amplifier
All three power amplifiers are of identical topology and use high efficiency Class G power amp
stages. The L/R amplifier channels are both rated at 50W. The bass channel is 100W, and
because of its higher power, uses higher current output transistors and slightly different
component values. Otherwise,operation is the same.
9