AirTek AT810PM Руководство пользователя - Страница 4
Просмотреть онлайн или скачать pdf Руководство пользователя для Кондиционер AirTek AT810PM. AirTek AT810PM 12 страниц.
Печатать страницу
USE & OPERATION (CONTINUED)
FILLING WITH WATER
It is ideal to use the Continuous Water Supply Connection to run the unit for long periods of time without
refilling the tank. This also helps prevent pump failure in case the cooler is running with inadequate water
in the tank.
CAUTION: Unplug the unit from the electrical power outlet before filling or emptying the water tank.
Continuous Water Supply Connection:
For a continuous water supply, you will need a garden hose that is connected to a main water supply.
Note: The garden hose is not included. Please make use of a garden hose which is compatible with
the unit connection.
•
Locate the male connector at one end of the garden hose. Insert
the garden hose connector into the water inlet valve of the cooler.
Screw and tighten the water inlet valve onto the threaded part of
the garden hose connector, making sure the hose connector is
secured to ensure there will be no leaks. If there is leakage, the
hose and the water inlet valve may not be connected properly.
Try to disconnect, replace and tighten the water inlet valve again.
•
When the connection is secured, turn ON the water supply and
the water will flow into the water tank of the cooler.
•
The cooler is now set so the water refills automatically.
•
When the water tank is full, the water inlet valve will automatically
stop the water supply from overflowing.
•
Please open the water valve for minimum flow as too much
pressure could damage the inlet pressure control system.
WARNING: The maximum water inlet pressure is 0.5 MPa.
Manual Water Tank Refill:
•
Using a portable container or a garden hose, you can refill the water tank manually by pouring water
into the water tank through the water inlet hole located at the top of the air cooler.
•
Check the water level indicator to know when the water tank is full. Do not fill water above the "Max."
water level mark to avoid water droplets collecting on the louvers.
WARNING: Always ensure the water in the water tank is above the minimum (Min.) water level mark for
both Continuous & Manual Water Refill. Running the unit in Cool mode with inadequate water may cause
pump failure.
Note: The water capacity refers to the total volume of water that can be contained within the air cooler
water tank and water distribution system. The water capacity in the tank at the "Max." indicator level may
be lower than the actual water capacity of the air cooler.
WARNING: Do not fill water tank with dirty water or salt water. This can damage the unit and Honeycomb
media.
Water Inlet Hole
3
Water inlet value
Garden Hose
Water Fill
Door
EN