Drolo Moon Rabbit Phaser Руководство - Страница 6

Просмотреть онлайн или скачать pdf Руководство для Музыкальное оборудование Drolo Moon Rabbit Phaser. Drolo Moon Rabbit Phaser 6 страниц. Phaser

Now let's try out the envelope follower for the rate:

With all knobs at noon like previously, let's flip up the left toggle switch to the env position.

You should notice that when you strum your guitar harder the rate increases. You can use the rate knob to define

the highest rate that it can jump to and use the env knob to find the sweet spot to suit your incoming signal.

Now try the envelope for the range:

Turn the depth all the way down, leave range at noon for now and flip up the right toggle switch to the env position.

Start with the env at noon and try to find the position of the range knob that sounds the best.

You will see that the phasing LED follows the envelope follower's signal. You can also add some LFO to the envelope

signal. Both will be added together to create the final wave. Usually you will need to turn the range knob down a bit

otherwise the sweep will be sitting in the higher frequencies only.

Once you have mastered the use of the envelope controlling range and rate individually you can now try to control

them both at the same time ;-)

A couple more tips and tricks:

- If you dial back fdbk completely and turn mix completely CW to wet only the phaser essentially becomes a vibrato

as without mixing some dry signal there is no phasing effect.

- Now if you increase fdbk while still leaving mix at at full wet you will get more filter-like sounds. If you combine that

with using just the envelope follower controlling the range and depth turned down it sounds a lot like an auto-wah.

You can use the range and env knobs to find the sweet spot of the sweep.

- If you turn down depth, you can sweep the range of the phaser with an expression pedal and have it work a bit like

a wah.

Hope you will enjoy this pedal and create magnificent noise!!

Thanks!

http://www.davidrolo.com