Dromida DB4.18 BL Руководство по сборке и техническому обслуживанию - Страница 14
Просмотреть онлайн или скачать pdf Руководство по сборке и техническому обслуживанию для Игрушечный автомобиль с мотором Dromida DB4.18 BL. Dromida DB4.18 BL 15 страниц.
Печатать страницу
LED LIGHTS
Make sure when you plug your LED
lights into Channel 3 of the receiver.
On/Off Switch
TUNING GUIDE
When tuning the Dromida SC4.18BL make sure that you have equal lengths from one side to the other on the
shocks and upper rods. Also, make sure to have the shock pre-load adjusters at the same setting from left to right.
They do not have to be the same front to rear.
PINIONS
The Dromida SC4.18BL comes stock with the 12 tooth pinion. To obtain higher top speeds you can install a larger
pinion gear onto the motor. This will, however, decrease your acceleration and run time. TIP: Smaller pinion equals
more torque, less top speed. Larger pinion equals more top speed, less torque.
SHOCK OIL
The Dromida SC4.18BL comes stock with 30 weight oil in the shocks. The handling can be tuned by changing the
shock oil to either heavier (bigger number) or lighter (smaller number). By putting heavier oil in the shocks, the
car will have less chassis roll and become more responsive. Putting lighter oil in the shocks will cause the car to
be less responsive and have more chassis roll. For smooth, high
traction surfaces, a thicker oil would be best. For low traction or
bumpy surfaces, a lighter oil would be best.
CAMBER
Camber refers to the angle at which the tire and wheel ride in
relation to the ground when viewed from the front or rear. Negative
camber is when the wheels lean inward and positive camber is
when the wheels lean outward. Usually adding a small amount of
negative camber (0° to -2°) will increase traction. However, adding
too much camber will decrease traction. The objective is to keep
as much of the tire as possible in contact with the running surface.
Never put in positive camber. Make sure that both sides are equal.
SHOCK SPRINGS
For low traction or bumpy surfaces, a softer spring should be used.
For high traction or smooth surfaces, a fi rmer spring should be used.
FRONT SHOCK ADJUSTMENT
Moving the tops of the shocks out (A) will increase steering
reaction but decrease front traction. Moving the tops of the shocks
in (B) will result in slower steering reaction but will be smoother
over bumps and have more front traction.
REAR SHOCK ADJUSTMENT
Moving the tops of the shocks out (A) will increase steering
reaction and decrease rear traction. Moving the tops of the shocks
in (B) will result in slower steering reaction but will be smoother
over bumps and have more rear traction.
STEERING
ESC
LIGHTS
To turn the LED lights on, switch the on/off switch
to the on position. Make sure you do not leave your
Dromida LED lights on when not running your vehicle.
You should disconnect your Dromida battery after
each run to help prevent this.
DIDC0055 v1.0 © 2015 DROMIDA, A HOBBICO COMPANY
We try very hard to have accurate and up-to-date information in this document. Any errors are unintentional.
2˚ NEGATIVE CAMBER
ADJUST LENGTH TO
CHANGE THE CAMBER
A
A
B
B
A
dromida.com