DroneTech SPLASH DRONE 3+ Инструкции по калибровке - Страница 2

Просмотреть онлайн или скачать pdf Инструкции по калибровке для Дроны DroneTech SPLASH DRONE 3+. DroneTech SPLASH DRONE 3+ 2 страницы.

 Now in compass calibration mode

 Pick up drone hold out (with straight arm) flat (Grey sticker away from you) ; top up

turn full circle to left. CCW

 Turn drone upside down still flat turn full circle to left (Grey Sticker Way from you)

CCW

 Drone on edge arrows up to 12 o'clock turn full circle to CCW

 Drone on edge arrows to 9 o'clock - turn full circle to left CCW

 Same again for 6 and 3 o'clock CCW

 Place drone on flat surface facing direction of flight.

 Lights should still be flashing Green, Yellow, Red



Wait about 90seconds for slow flashing

 Now calibrated.

 Power off drone to save calibration, power off controller.

3. Testing & START UP

 Check ALL SWITCHES UP on controller (GPS Mode)

 Power up controller, then Drone (Beep Tone)

 Wait for slow GREEN flashing and 11 or more satellites

 Check Drop system working & attach line

 Unlock Rotors – Left stick to bottom right, Right stick to bottom left – motors on.

 Move Right Hand lever up, the2 rear motors should go.

 Move Right Hand lever down, the front 2 motors should go

 Move Right Hand lever to Left, the right 2 motors should go

 Move Right Hand lever to right the left 2 motors should go.

 Fit Rotors

 Ready to fly

NEVER STORE YOUR BATTERIES FULLY CHARGED OR COMPLETELY EMPTY

GREEN,

REMEMBER:

www.dronetech.co.nz

@nzdronetech

GREEN.

@dronetechnz

09 836 6088