Daikin BRC7GA53 Руководство по эксплуатации - Страница 17
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Пульт дистанционного управления Daikin BRC7GA53. Daikin BRC7GA53 19 страниц. Wireless remote controller kit
Также для Daikin BRC7GA53: Руководство по эксплуатации (20 страниц)
Печатать страницу
• After the HEAT OPERATION is started, the
DEFROST OPERATION LAMP located on
the indoor unit lights up.
The indoor fan runs to discharge a gentle wind
automatically until the temperature inside the
air conditioner reaches a certain level. At this
time, the DEFROST OPERATION LAMP on
the light receiving unit indicator lights. Leave it
as it stands and wait for a while.
II. COOLING AND HEATING OPERATIONS
CAN NOT BE SWITCHED
• The receiving tone of the indoor unit
makes a long beeping sound.
An unavailable mode was set for the indoor
unit under operation changeover control.
III. THERE IS NO DISPLAY OR ALL PARTS
ARE DISPLAYED
• When a button on the remote controller is
pressed.
The batteries have run out.
12. HOW TO DIAGNOSE TROUBLE
SPOTS
I. EMERGENCY STOP
When the air conditioner stops in emergency,
the OPERATING INDICATOR LAMP on the
indoor unit starts blinking.
Take the following steps yourself to read the
malfunction code that appears on the display.
Contact your local dealer with this code. It will
help pinpoint the cause of the trouble, speed-
ing up the repair.
2 4
6
TEMP
TIME
CODE
RESERVE CANCEL
UNIT N
.
O
English
ON OFF
UP
2 4
DOWN
6
FAN
TIMER
MODE
3 5
SWING
7
/TEST
1
TEST
1
Press the INSPECTION/TEST OPERATION
BUTTON to select the inspection mode "
" " appears on display and blinks.
"UNIT No." lights up.
2
UP
DOWN
Press PROGRAMMING TIMER BUTTON and
change the unit number.
Press to change the unit number until the indoor unit
beeps and perform the following operation accord-
ing to the number of beeps.
Number of beeps
3 short beeps.......... Perform all steps from
6
1 short beep ........... Perform
1 long beep............. Normal state
MODE
3
Press OPERATION MODE SELECTOR BUT-
TON.
" " on the left-hand of the malfunction code blinks.
4
UP
DOWN
Press PROGRAMMING TIMER BUTTON and
change the malfunction code.
Press until the indoor unit beeps twice.
MODE
5
Press OPERATION MODE SELECTOR BUT-
TON.
" " on the right-hand of the malfunction code blinks.
6
UP
DOWN
Press PROGRAMMING TIMER BUTTON and
change the malfunction code.
Press until the indoor unit makes a long beep.
The malfunction code is fixed when the indoor unit
makes a long beep.
3
.
3
and
6
steps.
".
to
12