DROPSA MiQueL EXT PRO Руководство по эксплуатации и техническому обслуживанию - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Системы смазки DROPSA MiQueL EXT PRO. DROPSA MiQueL EXT PRO 14 страниц. Air/oil modular minimal system with external pump
Печатать страницу1lt Reservoir
TECHNICAL SPECIFICATIONS
Reservoir capacity
Air inlet pressure
Air inlet pipe
Oil outlet pipe
Pressure switch calibration
Maximum pressure switch load
Maximum electric level load
6. UNPACKING AND INSTALLATION
6.1 UNPACKING
Once the suitable location for installation has been identified, open the package and remove the unit.
Check that it was not damaged during transport or storage.
The packaging material does not require special disposal precautions as it is not in any way dangerous or polluting.
6.2 INSTALLATION
Allow a sufficient amount of space for installation, leaving a minimum perimeter space of 100 mm (3,93 in.).
Install the unit at "shoulder height" to prevent abnormal positions or the possibility of impacts.
Use the brackets with the holes (see chap. 12) to fix the unit properly. It is also possible to disassemble the brackets from their
current position and reassemble them in the prepared threaded holes for side or corner installation.
It is prohibited to use the unit if submersed in fluids or in a particularly aggressive or explosive/inflammable environment if not
previously prepared for that purpose by the supplier.
Use safety gloves or glasses as specified in the safety sheet for the lubricant.
Do not use aggressive lubricants with NBR gaskets. In the case of doubt, contact the Dropsa SpA technical office to receive a
detailed card about the recommended oils.
Do not ignore the hazards to health and comply with the health regulations.
6.3 PNEUMATIC CONNECTIONS
Before making the connection, check that the valve for the main air, the manual sliding valve and the check valves (air and oil)
are closed. Make sure that the inlet pressure does not exceed 7bar.
Use fittings and pipes that are suitable for the operating pressures, push-in connection for Ø10mm pipe.
ATTENTION: Always install a regulator filter with condensate recovery on the air inlet. Any unfiltered deposits
or sediments could irreparably damage the product.
Pressurized reservoir for MiQueL EXT (optional)
Pressure switch
Pressure gauge
1lt – 3lt
4bar ÷ 7bar [87psi ÷ 101,5psi]
Ø6mm
Ø6mm
6bar [87psi]
Voltage free contact maximum voltage 250V
Maximum power 100W
0,2A @ 30V
Loading cap
Visible level
3lt Reservoir
Air inlet
Oil Outlet
Mounting
brackets
Reservoir
Minimum electric
level
5