anko BL1015-GS Руководство пользователя - Страница 8

Просмотреть онлайн или скачать pdf Руководство пользователя для Блендер anko BL1015-GS. anko BL1015-GS 12 страниц.

CRUSHING ICE

1. Place the appliance on the flat horizontal surface and make sure it is not connected to mains

power.

2. Use ice cubes approximately 15mm*15mm*15mm in size. Remove the measuring cup and

jar lid and place the ice cubes in the jar. It is recommended to add water to facilitate the smooth

running of the appliance. Use 2:3 proportion of ice and water. The amount of mixture should

not exceed the max level mark as indicated on the jar. And then close the jar lid and measuring

cup properly.

3. Connect the appliance to mains power, and then push the power switch to "ON" position.

4. Turn the speed dial to the "HI" speed setting or push the function switch to "Pulse" setting

and the appliance starts to crush ice.

5. After crushing ice (maximum 3 minutes), turn the speed dial to "STOP" position.

6. You may add ingredients into the jar through the center opening of jar cover during operation.

First, turn OFF the appliance to make it stop working, and then remove the measuring cup and

add the ingredients into the jar through the center opening on the jar. Replace the measuring

cup into position. Then turn ON the appliance.

NOTE:

1) During operation, if the mixture is too thick to be blended, use the tamper (refer to

"Tamper" description mentioned above).

2) DO NOT remove the jar from the motor unit during use. If it is necessary to remove the jar,

first turn OFF the appliance and make sure the blender blade has stopped rotating. Then remove

the jar.

3) The maximum operating time per cycle must not exceed 3 minutes. Allow minimum 10

minutes rest time between two consecutive cycles to prevent damage to the electric motor. The

appliance must rest for at least 30 minutes after 10 cycles.