AIRTEQ 9912S Руководство - Страница 18

Просмотреть онлайн или скачать pdf Руководство для Замки AIRTEQ 9912S. AIRTEQ 9912S 18 страниц.

If the lock is not working properly, the following chart may be used as a guide to locate

and correct the problem.

Because the lock receives its power from the electronic control systems, a thorough

check of the control system should be conducted. Using a volt/ohm meter know to be

accurate, verify the correct power inputs at the appropriate connector pin(s). If the

proper electronic signal is not evident, begin checking "up-stream" from the connector. If

the electronic signal input is correct, the problem is within the locking device, use the

following chart to locate and correct the problem.

The recommended voltage at the lock is 120VAC. If the correct voltage is not evident,

begin checking "upstream" from the lock. If the voltage is correct, the problem is within

the locking device. Use the following chart to locate and correct the problem.

PROBLEM

LATCHBOLT WILL NOT RETRACT

LATCHBOLT WILL NOT EXTEND

LOCK RETRACTS BUT WITH LOW STALL FORCE Bad Motor or Lock Connection

KEY CYLINDER NOT WORKING PROPERLY

SECURE LOCK STATUS SIGNAL NOT GIVEN

DOOR POSITION SIGNAL NOT GIVEN

TROUBLESHOOTING

CHECK

Mechanical Interference

Poor on No Power to the Lock

Broken or loose wiring

Faulty Key Switch

Mechanical Interference

Broken or loose wiring

Faulty Key Switch

Low Voltage (Required voltage is 120VAC)

Mechanical Interference

Key Cylinder Engagement/Position in Lock

Broken or Loose Wiring

Faulty Status Switch

Mechanical Deadlock Not Functioning

Motor or Solenoid Positioned too Low

Switch Arm adjustment

Broken or Loose Wiring

Door Adjustment Needed

Magnetic Door Position Sensor adjustment

needed