Annovi Reverberi Blue Clean 353 Руководство по эксплуатации - Страница 9

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Мойка высокого давления Annovi Reverberi Blue Clean 353. Annovi Reverberi Blue Clean 353 10 страниц. Annovi reverberi jet pump product manual

Печатать страницу

English

TROUBLESHOOTING

Problem

Pump does not reach working

pressure

Pressure drops during use

Motor "sounds" but fails to start

Motor fails to start

Water leakage

Appliance noisy

Oil leakage

TSS versions only: motor starts

even with gun trigger is released

TSS versions only: no water deliv-

ery when gun trigger is depressed

(with supply hose connected)

If the motor starts and does not restart during operation, wait 2-3 minutes before repeating the start-up procedure (overload cutout has been tripped).

If the problem recurs more than once, contact your nearest Authorized Service Centre.

Possible causes

Nozzle worn

Water filter fouled

Water supply pressure low

Air being sucked into system

Air in pump

Adjustable nozzle not positioned correctly

Water intake from external tank

Intake water too hot

Nozzle clogged

Insufficient power supply

Voltage loss due to use of extension cable

Appliance not used for a long period of time

Problems with TSS device

No electrical power

Problems with TSS device

Appliance not used for a long period of time

Seals worn

Water too hot

Seals worn

Nozzle clogged

High pressure system or pump hydraulic circuit not

watertight

Nozzle clogged

Remedy

Replace nozzle

Clean filter (fig.5)

Turn on water supply tap fully

Check tightness of hose fittings

Switch off the appliance and keep depressing and releas-

ing the gun trigger until the water comes out in a steady

flow. Switch the appliance back on again.

Turn the adjustable nozzle (E) (+) (fig.3)

Connect appliance to the mains water supply

Reduce temperature

Clean nozzle (fig.5)

Check that the voltage of the mains power supply line is

the same as that on the plate (fig.2)

Check characteristics of extension cable

Contact your nearest Authorized Service Centre

Check that the plug is firmly in the socket and that the

mains voltage supply is present (*)

Contact your nearest Authorized Service Centre

Using the tool (L) unjam the motor from the hole at the

rear of the appliance (in models with this feature) (fig.5)

Have the seals replaced at your nearest Authorized

Service Centre

Reduce temperature (see technical data

Contact your nearest Authorized Service Centre

Clean nozzle (fig.5)

Contact your nearest Authorized Service Centre

Clean nozzle (fig.5)