FOVNO ES-3CS Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Аксессуары для велосипедов FOVNO ES-3CS. FOVNO ES-3CS 19 страниц. Electric sucker luggage rack

Печатать страницу

Introduction

Alarm System Instructions

1. Your rack is ﬁtted with a safety alarm which will alert you if the back loses its connection with the vehicle. The alarm

will sound if a suction foot leaks. In the even of this happening the N-Power system will automatically attempt to create a

vacuum seal using the built in pump.

2. The alarm module is ﬁtted with a standard USB which can be connected to your vehicle either via the vehicles own USB, a

USB adaptor or USB port on a sound system. The alarm will connect to the N-Power box wirelessly and will alert you in the

even of a pressure error. Double sided toe on the underside of the alarm can be used to hold it in place.

3. PLEASE NOTE: If you are using more than one electric rack system on your vehicle the alarm system may not operate

correctly due to a shared signal. While the alarm may not operate the N-Power box will still function as normal.

N-Power control box functions

· Charging: Charging the N-Power box is easy and thanks to the USB-C connector you can charge from a phone charger power

band or a USB charger. Simply remove the waterproof / dust cover and charge with the included USB C wire.

· The N-Power control box features USB lights that tell you the level of charge in the battery. An orange light indicates the system

needs charging, blue means full and a red light indicate the system is being charged. To check the battery level press the button

on the N-Power control box.

Quick release air hose connection

USB Type C connector

(Red light when charging

blue light when fully charged.）

(Dust seal: When the rack is not in use

please use the dust seal to protect the

pneumatic connections.)

Dust seal plug

N-Power Control Box

Power button

Battery health check button

red orange blue

（The blue light is normal, and the red

and orange are charged immediately）

A button for the pairing switch

Alarm

The underside of the alarm

Pairing method of alarm and control box

Pairing

1. Clear data: There is a small hole on the back of the

alarm that is a button for the pairing switch. After the

alarm is connected to the power supply, press the

switch button in the small hole for about 10 seconds

When the indicator light of the alarm is oﬀ, it meansthat

the original data is cleared.

2. Use the same method to press the switch button in

the small hole of the alarm for about 3-5 seconds. After

the alarm indicator lights up, start the control box, and

then stop pressing the pairing switch. At this time, the

alarm buzzes, the pairing is complete.

blue