DS18 FRX2K Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Усилитель DS18 FRX2K. DS18 FRX2K 11 страниц.

It is advisable to test the ground with an ohmmeter between the ground cable and the

negative battery cable to ensure a good low resistance connection. Some allows used

in modern cars do not offer the best ground. If you believe this is the case - first consult

with the vehicle manufacturer.

Run the speaker wire to the speakers. It is advised that you leave some extra

wire at this point. You can fix it later.

If you haven't done so already, mount the amp now.

Connect the power and ground to the amplifier.

ONLY AFTER THIS STEP - SHOULD YOU INSTALL THE FUSE AT THE BATTERY.

Connect the remote wire from the head unit to the amplifier.

Now is a good time to turn on the amp for the first time. Make sure it turns on

properly and does not go into protection mode.

Connect the speaker wires to the amp and speakers (make sure the amp is

off first). Make sure the polarity (+) and (-) is correct.

10. Connect the RCA's to the amp.

11. Double check the amplifier controls at this time. Make sure everything is set

correctly for your system.

12. Now you're ready to play it for the first time. It is best to leave the gain all the

way down at first. Start with the head unit volume low and work your way up.

13. Now you can tune the amp. Take your time and make only one adjustment at

a time. It may take some time to get the system fully adjusted. During this time

the amp is drawing current from the battery. You should check the battery

voltage from time to time and recharge it, if it gets low. That's it. You're done.

Now have fun.