DS18 GEN-X112LD Руководство пользователя - Страница 5
Просмотреть онлайн или скачать pdf Руководство пользователя для Сабвуфер DS18 GEN-X112LD. DS18 GEN-X112LD 6 страниц. 1x12" subwoofer in a ported box
Печатать страницу
INSTALLATION INSTRUCTIONS
Professional
installation
authorized
DS18
recommended!
performance of your new gear may not
be satisfactory. In the event that you
decide to do your own installation,
please read and follow this manual
carefully.
Failure
compromise
the
product, your automobile, and possibly
void the product warranty.
Use this Subwoofer Box with an external
Monoblock subwoofer amplifier that
can handle 2 ohm load impedance and a
maximum of 450W RMS continuous
power, otherwise the amplifier or the
Subwoofer can get damaged. In case
that you need to install an amplifier
please refer to the amplifier's instruction
manual to perform the installation of the
amplifier before the use this Subwoofer
Box.
Do Not Connect this directly to the
factory radio or aftermarket radio
speaker output. This will not be enough
power for the subwoofers and could be
bad for the radio's amplifier if is not 2
ohm stable.
Secure the subwoofer box with a strap
or bracket to screw it down in case this
box is loose on your trunk or a SUV
cargo area to avoid this moving around
4
by
an
dealer
is
highly
Otherwise,
the
to
do
so
may
integrity
of
this
which will damage the Subwoofer or box
itself. In case of accelerating or hard
braking this will reduce the possibility of
movement! Major injuries may occur in
case of an accident if this is not secured
properly.
If you already have installed
the amplifier, then follow these
simple steps:
1
Connect the subwoofer box to the
amplifier
using
speaker wire and make sure the polarity
(+) and (-) is correct, otherwise the
sound will be affected.
2
You are now ready to play it for the
first time. It is best to leave the gain all
the
way down in the beginning. Start with a
low volume and work your way up.
3
Now you can tune the amp. We
recommend using the Low Pass Filter at
120Hz or lower depending on your
system. Take your time and make only
one adjustment at a time. It may take
some time to get the system fully
adjusted. During this time the amp is
drawing current from the battery. You
should check the battery voltage from
time to time and re-charge it if it gets
low. That's it! You are done.
Now have fun!!
a
minimum
12Ga