DSC ALEXOR Краткое руководство пользователя - Страница 5
Просмотреть онлайн или скачать pdf Краткое руководство пользователя для Система безопасности DSC ALEXOR. DSC ALEXOR 7 страниц. Two-way wireless security system
Также для DSC ALEXOR: Руководство по программированию (5 страниц)
Печатать страницу
Trouble Conditions
When a trouble condition is detected, the System Trouble indicator will turn on and the
keypad will beep every 10 seconds. Press # to silence the beeps. Press
trouble condition. The Trouble indicator will flash. Use the scroll < > buttons to view troubles.
Trouble
Alternate Communicator
Trouble
Service Required (Press 1
for more information)
Loss of AC Power
Telephone Line Fault
Failure to Communicate
Module/Sensor Fault
Module/Sensor Low Battery
Loss of Time & Date
Blank Display/No Response
"Panel Response Not
Received" message
Orange Trouble LED on the
control panel
DSC Alexor
Comments
Indicates SIM Card Lock, GSM Trouble,
Ethernet Trouble, Central Station Receiver
Trouble, Supervision Trouble and SMS Config.
Trouble. Press < > to scroll through individual
troubles.
Indicates Low Battery, System Trouble,
System Tamper or RF Jam detected.
If the building and/or neighborhood has lost
electrical power, the system will continue to
operate on battery power for several hours.
The system has detected that the telephone
line is disconnected.
The system attempted to communicate with
the monitoring station, but failed. This may be
due to a Telephone Line Fault.
The system is experiencing difficulties with
one or more module/sensor on the system.
Continue to press 5 to navigate through the
Zone, Keypad and Siren fault menus.
The system has detected a low battery
condition with one or more module/sensor on
the system. Continue to press 7 to display to
zone(s), wireless key(s), key-pad(s), siren(s)
and prox tag(s).
If complete power was lost (AC and Battery),
the time and date will need to be programmed.
Press *.
Keypad battery may have discharged beyond
the usable level.
The keypad has not lost wireless
communication with the panel. Occasional
display of this message may be caused by
local radio frequency interference.
The PC9155 has detected that an RF Jam
condition has been present for at least 20
seconds.
*
2 to view the
Action
Call for Service.
Call if service is required.
Check AC Connection. Call if
service is required.
If no dial tone on phone, call
phone company.
If dial tone on phone, call
Keyhole for service.
Send signal to Monitoring
Company. Call to put account
out of service prior to sending
signal.
May clear on its own in 24-
hour period. If not, replace
battery. If problem persists,
call for service.
Replace battery.
Reprogram Time & Date. (See
page 4)
Replace battery.
If trouble persists, call for
service.
If trouble persists, call for
service.
Page 5 of 7