DSC PC2580 Руководство по эксплуатации - Страница 9

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Система безопасности DSC PC2580. DSC PC2580 13 страниц.

Печатать страницу

LCD600 MESSAGE DISPLAY KEYPAD

Important:

Test your system regularly. Follow the guidelines for correcting system trouble conditions;

have any system trouble conditions you cannot correct yourself attended to by your installer.

[F] Key: Press and hold this key for 2 seconds to sound an [F] Key alarm

[A] Key: Press and hold this key for 2 seconds to generate an [A] Key alarm

[P] Key: Press and hold this key for 2 seconds to generate a [P] Key alarm.

These keys must be enabled by your Installer before they become

functional. Your Installer will tell you how these keys operate on your

∗

Press [

• to select the displayed

function

Press [#]:

Trouble

• when an error is made in

entering an Access Code,

Armed

then enter the code again

• to return to "Ready" after

∗

using [

] commands

Press [<]:

• to view the previous function

or message

Press [>]:

• to view the next function or

message

system.

Disarming Your System

Enter the premises through the designated Entry-Exit door. The keypad will sound a constant tone to

indicate that the system must be disarmed.

Go to the keypad and enter an Access Code. If an error is made entering the code, press the [#] Key and

enter the code again. When a correct Access Code is entered, the "Armed" light will be shut OFF, and the

sounder will be silenced - your system is now disarmed.

An Access Code must be entered before the Entry Delay expires or an alarm will sound. If you require a

longer or shorter Exit Delay time, your installer may change this time to suit your needs.

If an alarm occurred while the system was armed, the "Memory" light and the Zone Lights of the zones

that went into alarm will FLASH for two minutes. Press the [#] Key to cancel the flashing display and

return the keypad to the "Ready" mode. Refer to "Display Alarm Memory" for instructions on displaying

the zones that went into alarm.

IMPORTANT NOTE: If you return to the premises and find that an alarm is in progress or that

there are alarms in memory, do not enter the premises as an intruder or fire condition may

be present. Go to a neighbour and, if your system is monitored, contact the monitoring

station. Your monitoring station will advise of what action has been taken as a result of the

alarm and whether the premises are safe to enter. If your system is not monitored, call the

local police to investigate.

LCD6OO

The LCD600 Keypad will display messages while you disarm your system. Refer to Page

18 for instructions on disarming the system with the LCD600 Keypad.

Engineer Reset

If an alarm occurs and your system is set for Engineer Reset, you must call your alarm company to reset the

system before it can be re-armed. In this instance, the "memory" light will remain ON until reset by the installer.

Bypassing Zones

A bypassed zone will not cause an alarm. Zones may be bypassed to allow access to part of the

protected area while other zones are armed. For example, bypassing the zone protecting your living room

would allow you to remain in the room while other zones on your system are armed.

To Display Bypassed Zones:

∗

With the system disarmed, enter [

][1] or [

will inform you if an Access Code is required to bypass zones or to view bypassed zones. When the

command is entered, the Zone Lights for any bypassed zones will come ON. Ensure that any zone

displayed as being bypassed has been bypassed intentionally . Zone bypasses are automatically

cancelled when the system is disarmed.

][1][Access Code] to display bypassed zones; your installer