DSC PC3000 Руководство по эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Система безопасности DSC PC3000. DSC PC3000 15 страниц.
Также для DSC PC3000: Руководство по эксплуатации (15 страниц)
Печатать страницу
Disarming
Enter the premises only through the door indicated by your installer as the entry
door. The keypad sounder will be ON. Go to the keypad and enter the [4 digit
access code]. If an error is made entering the code, press the [#] key and enter the
code again. The "Armed" light will go out and the keypad sounder will stop. The
correct access code must be entered before the allowed entry time expires. The
entry delay time may be changed by the installer.
If an alarm occurred while the panel was armed, the "Memory" light and the light for
the zone which caused the alarm will start to flash and will continue flashing for 2
minutes. At the end of 2 minutes, the keypad lights will stop flashing and the keypad
will return to the normal Ready condition.
If you return home and find an alarm has occurred while you were away, it is possible
that an intruder may still be on the premises. Go to a neighbour's and if your system
is monitored, call the monitoring station. They will advise what action has been
taken as a result of the alarm and whether the premises are safe to enter. If your
system is not monitored, call the local police to investigate.
Alarm Memory Display
If the "Memory" light is on, an alarm has occurred since the last time the panel was
armed. The alarm memory will automatically be displayed when the system is
disarmed (see Disarming).
*
Press the [
] then [3] keys to display which zone caused the alarm.
The alarm memory will be cleared when the panel is re-armed.
Press [#] to return to Ready.
Zone Bypassing
Bypassed zones do not cause an alarm. Use zone bypassing when access is
needed to part of the protected area. Also, damaged wiring or contacts on a zone
may be temporarily bypassed until repairs can be made so that the panel can be
armed.
To bypass zones, enter [
for zone 1, [1][6] for zone 16. If the [0] key is pressed twice instead of a zone number,
all zone bypasses will be removed. If the [9] key is pressed twice, the last group
of zones which was bypassed will be recalled. Press [#] to return to Ready.
For security reasons, your installer may prevent the bypass command from
operating on certain zones.
The "Bypass" light is ON as long as at least one zone is bypassed. Do not
unintentionally bypass zones when arming. Zone bypasses are automatically
cancelled each time the panel is disarmed and must be re-applied before the next
arming.
*
],[1] and the zone numbers to be bypassed. i.e. [0][1]