DAITEM L2612 Уведомление об установке - Страница 6

Просмотреть онлайн или скачать pdf Уведомление об установке для Система безопасности DAITEM L2612. DAITEM L2612 16 страниц.

Печатать страницу

Programme the chanel code by pressing the "0" and "1" push but-

tons as shown:

Press both keys

at the same

time until the

light goes out

Start customising

Warning: if, during programming, you leave more than 7 seconds

between entries or if you do not press "0" and "1" at the same time

or for long enough, you will quit the programming mode: the red

light flashes, the programming is incorrect. Start the customising

procedure again from the beginning.

To test the channel code, press the "1" push button for a few

seconds: the medallion light indicator comes on for 2 seconds and

then goes out.

The control panel responds with a series of two-tone audible

signals: "Beeep-bip, beeep-bip, beeep-bip,..." and the light indicator

corresponding to the chosen channel comes on.

Channel

Reaction of the control panel in the test mode

Alert Call

2-tone audible message and the Alert light indicator

flashes

Silent Alarm

2-tone audible message and the Silent Alarm light indicator

flashes

Audible Signal

2-tone audible message and the Batteries light indicator

flashes

The telephone dialer responds with a high pitched beep.

If this does not happen, start the medallion customisation proce-

dure again after checking the series of "0" and "1" for the installa-

tion code and channel.

Note for control panels equipped with a radio reception light indi-

cator: although the medallion has the Dual Frequency technology,

it is normal that the radio reception light indicator does not come on

when the medallion is used.

Type the series

Press both keys at the same

of 2 keys

time until the light goes out.

corresponding to

The light then comes on again

the channel code

for 5 seconds to indicate

successful programming.

End of customising

Put the control panel in the normal mode and carry out a real test.

Check the reaction of the control panel (or telephone dialer interfa-

ce) using the following table.

Chanel

Alert Call

Silent Alarm

Audible Signal 4 audible beeps

If the control panel (or telephone dialer interface) responds as

described above, the medallion implementation procedure is com-

plete.

FIG. F

Place the medallion cover sliding part opposite the base rail and

press to fit the two parts together.

Slide the cover on the base until the medallion case is comple-

tely closed.

The medallion is now ready to use.

INDICATION OF LOW BATTERIES

The batteries are low when the light indicator only comes on faint-

ly or not at all. In this case, see your local dealer.

Response of the control

Reaction

panel in the normal mode

of the sirens

The integrated siren is

Sounded

sounded for 90 secs and

for 90 secs

the alarm is memorised

No reaction.

No reaction

The Silent Alarm

is memorised on

control panel

No reaction

and no memorisation

Closing

Reaction of the

telephone dialer

Alert terminal

connection is

activated for 1,5 sec

Prog. 1 or Prog. 2

terminal connection

is activated

for 1,5 sec

No reaction