DAITEM SJ608AX Руководство по установке - Страница 7

Просмотреть онлайн или скачать pdf Руководство по установке для Система безопасности DAITEM SJ608AX. DAITEM SJ608AX 8 страниц. 2 function remote keyfob with information feedback, bi-protocol 4 function remote keyfob with information feedback,8 function 4 key remote keyfob with information feedback

Печатать страницу
LED indication table
Command
LED colour and status
sent to:
flashes ORANGE
Alarm control
while the key
panel
is pressed then...
• An Optwin
®
external
flashes ORANGE
receiver
once then...
• A doorphone
controller
(1) This is the indication used when the control panel receives an ARM order even if there is a fault or a door or window open.
(2) ARMING blocked means that the intrusion system has been unable to arm owing to a system fault.
The user must check the control panel for more information.
7.2 Confirmation of receipt
This display only concerns commands with an Optwin
Confirmation of receipt is displayed when the product acknowledges the command without indicating its status.
It indicates to the user that the radio message has been received and taken into account (examples: pulse function without
position contact or timer function).
LED indication table
Command sent
LED colour and status
to:
• An Optwin
®
external
flashes ORANGE
receiver
once then...
• A doorphone
controller

7.3 Protected or locked keys

When the keyfob has been locked using a code or is in protected mode (SJ608AX with cursor in middle position) the LED
quickly flashes red to indicate locking/protection when a key is pressed (the LED stops flashing when the key is released or
after the key has been pressed for longer than 2 s).
7.4 Keyfob battery fault
This fault is indicated by the LED flashing red four times at the start of a sequence when a key is pressed and for however
long the key is pressed.
The battery must be changed within 4 weeks.
The control panel responds to remote control battery faults: Following a system command (for example, ON or OFF), the
control panel issues the voice message "Beep, fault, voltage, remote control unit X".

8. Maintenance

8.1 Changing the battery

To replace a low battery, see chapter "2. Preparation".
IMPORTANT
• When a keyfob is powered (battery changed) in locked
mode it remains in locked mode.
• The parameters set do not change when the keyfob battery
is changed.
• After the battery change , the low battery fault
announcement by the Control panel will be removed
following a second press of a remote control button (for
example press OFF twice).
lights up steady GREEN for 1.5 s
flashes GREEN 3 times
lights up steady RED for 1.5 s (1)
flashes RED 3 times
lights up steady GREEN for 1.5 s
lights up steady RED for 1.5 s
®
wireless product.
lights up steady GREEN for 0.5 s
7
Meaning
• Total/Partial or group DISARMING
or
• Silent alarm
Total/partial or group DISARMING (with memory of alarm)
Total/partial or group ARMING
ARMING blocked (2)
• position contact OPEN
or
• relay ENABLED (e.g.: toggle switch function)
• position contact CLOSED
or
• relay DISABLED (e.g. toggle switch function)
Meaning
Radio-transmitted command received correctly
(e.g. pulse function without status indication)
IMPORTANT: make sure you
insert the battery the right way
round with the "+" facing up.
Dispose of waste batteries
in the appropriate recycling
containers.
Li