DSC PowerSeries PC1832 Руководство - Страница 7

Просмотреть онлайн или скачать pdf Руководство для Система безопасности DSC PowerSeries PC1832. DSC PowerSeries PC1832 18 страниц. System enhancement module
Также для DSC PowerSeries PC1832: Руководство по установке (17 страниц), Руководство по установке (13 страниц), Руководство по установке (20 страниц)

DSC Power Series PC1616 PC1832 PC1864 System Manual

The system can generate two different alarm sounds:

Continuous Siren = Intrusion (Burglary Alarm)

Temporal/Pulsed Siren = Fire Alarm

Intrusion (Burglar) Alarm Continuous Siren

If you are unsure of the source of the alarm approach with caution! If the alarm was accidental, enter

your Access Code to silence the alarm. Call your central station to avoid a dispatch.

Fire Alarm Pulsed Siren

Follow your emergency evacuation plan immediately! If the fire alarm was accidental (i.e. burned toast,

bathroom steam, etc.), enter your Access Code to silence the alarm. Call your central station to avoid a

dispatch. Ask your alarm company if your system has been equipped with fire detection. To reset the

detectors, see the Sensor Reset section.

Trouble Conditions

When a trouble condition is detected, the Trouble or System indicator will turn on, and the keypad will

beep every 10 seconds. Press the [#] key to silence the beeps. Press [*][2] to view the trouble condition.

The Trouble or System indicator will flash. The corresponding trouble will be represented by numbers 1-

LED/Digit Trouble Condition

Service Required

(Press [1] for more

information)

Loss of AC Power

Telephone Line Fault The system has detected that the telephone line is cut.

Failure to

Communicate

Sensor (or Zone) Fault The system is experiencing difficulties with one or more sensors.

Sensor (or Zone)

Tamper

Sensor (or Zone) Low

Batt

Loss of Time & Date

https://alpha.adt.com/help/61[11/12/2018 9:40:17 PM]

Comments

(1) Low Batt (2) Bell Circuit (3) System Trouble (4) System Tamper (5)

Modulate Supervision (6) RF Jam Detected (7) PC5204 Low Batt (8)

PC5204 AC Failure

If the building and/or neighborhood has lost electrical power, the

system will continue to operate on backup for several hours.

The system attempted to communicate with the monitoring station, but

failed. This may be due to Trouble 3.

The system has detected a tamper condition with one or more sensors

on the system.

If the system has been equipped with wireless sensors, one or more

has reported a low battery condition.

If complete power was lost, the time and date will need to be re-

programmed.