ANSITE AST-2008D2 Руководство пользователя - Страница 3

Просмотреть онлайн или скачать pdf Руководство пользователя для Система безопасности ANSITE AST-2008D2. ANSITE AST-2008D2 10 страниц.

and stop alarm.

Each guard area is corresponding to a LED indicator on the front panel,when alarm take

place,the corresponding LED light up, then the alarm system dial out the telephone numbers

and alarm.

The guard zone doesn

be configured into the same guard zone and light up the same alarm LED. As how to configure

a detector to a guard area will be illustrated later.When this alarm unite manufctued out,its

initial status is setting full guard.

In this AST-2008D standard configuration kit( standard configuration),the inclosed door

entry detector( door contacts) is configured to the guard zone 2st, the enclosed infrared detector is

configured to guard zone 1st, according to your need ,you can add any detectors to guard

1,2,3,4,which corresponding to the LED indicator respectively.

Partial guard setting:

Each of the four guard zone can be opened or closed independently by input digit key on the

keypad as follows:

Open guard zone 1: press four digit password first,then press: set+1

Close guard zone 1: press four digit password first,then press: set+2

Open guard zone 2: press four digit password first,then press: set+3

Close guard zone 2: press four digit password first,then press: set+4

Open guard zone 3: press four digit password first,then press: set+5

Close guard zone 3: press four digit password first,then press: set+6

Open guard zone 4: press four digit password first,then press: set+7

Close guard zone 4: press four digit password first,then press: set+8

If a guard zone is set closed,the detectors of the zone will not trig any alarm even in guard setting

status.

Emergency alarm function:

When met emergency event, you can press the panic key, the system will immediately put into

emergency alarm state,if you press the panic key

will give out loud sound as well as dial out the pre-stored telephone numbers, and if you press the

panic key "S" on the remote controller, the system

pre-stored telephone numbers as well.

There is also an panic key on the forward side of the alarm main set.

Alarm System setting method:

1.Store alarm telephone number

Press key on the keypad as follows:

"four digit user password" + "store" + "group number(1~6)" + "*" + telephone number +

"store"

For example, if you want to store first group telephone numbers such as "66778899", you press

t mean the same area ,that is to say, detectors in different places can

s siren will not give out sound but dial out the

on the remote controller,the system

s siren