28 GORILLA 28-0010366 Руководство пользователя - Страница 3
Просмотреть онлайн или скачать pdf Руководство пользователя для Зарядное устройство 28 GORILLA 28-0010366. 28 GORILLA 28-0010366 4 страницы. Wireless charging station
Печатать страницу6. FCC Regulatory Information
FCC ID: 2AX2O-280010320 Model: 28-0010366
This device complies with Part 18 of the FCC Rules.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the equipment being interfered with.
•
Increase the separation between the charger and the equipment subject to interference.
•
Connect the equipment into an outlet on a circuit different from that to which the charger is
•
connected.
Consult the dealer or an experienced radio/TV/electronics technician for help.
•
CAUTION: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
7. RF Exposure Notice
The charger employs receiver equipment proximity sensing. There are no user adjustments and
charging commences only when the internal microcontroller detects valid receiver equipment
and permits commencement of power transfer. After placing your receiver on the charger,
maintain a 2.5cm separation distance to meet applicable requirements.
User Manual and User Information.