AirTime ATX6 Руководство по установке и эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Трансивер AirTime ATX6. AirTime ATX6 16 страниц. Wireless wall clock transceiver
Печатать страницуATX6 Installation and User Guide
Installation:
1. Choose an appropriate location to install the ATX6 on a
wall.
a. If you intend to use the ATX-GPS accessory to
synchronize the ATX6, then a site should be
selected that is within the 25-foot cable limit of
the ATX-GPS to a window or skylight having an
unobstructed view of the sky.
b. If the ATX6 will be used in synchronizing a wide
area / campus, then the site should, generally,
be close to the center of the facility; rather than
at the perimeter.
c. If you intend to synchronize the ATX6 to an ATX
Transceiver in Master mode then select a site
within approximately 130 feet from where the
ATX Transceiver will be located..
2. If synchronizing another system to the ATX6, or if
synchronizing the ATX6 to another system via "Dry
Contact" (Relay) Closure, install the shunt jumper onto
the circuit board's J7 Pins, according to the following
diagrams:
CAUTION: Make sure the AC Power Cord is unplugged before
opening the ATX6 enclosure
To access the jumpers, remove the two screws from top
case cover.
Carefully slide the front panel assembly up until the
jumper's location is accessible.
Change the jumper settings as needed
Slide the front panel assembly back into place and
secure the top case cover.
Page 3
Synchronizing a LTRX-512 to ATX6 using Sync Relay
closure
(Program ATX6 Relay closure at 12:00AM)
Verify Jumpers are "Open" as shown for Sync Output.
To access jumpers see page 3.
ATX6 Installation and User Guide
Page 24