DSP AD1200 Инструкция - Страница 8

Просмотреть онлайн или скачать pdf Инструкция для Телефон DSP AD1200. DSP AD1200 12 страниц.

2.19 Enter Installer Test Mode

To listen to the recorded message after recording, a telephone must be connected in parallel with

the telephone line input. If the recording is unsatisfactory you can record again. All telephone num-

bers programmed will be displayed. If telephone number is busy or not answered it will be by-

passed.

Enter installer code:

Enter installer code:

The hardware of the AD1200 provides as an optional feature of connecting 315 or 433 MHz wire-

less Remote Devices like Remote Controls and Remote Panic Buttons.

The Installer may enable this feature as following:

Press: PROG

To disable the feature the Installer shall do the following:

Press: PROG

2.22 Recording a new Remote Device

If the AD1200 is equipped with the optional Remote Device functionality and the feature is enabled

as described under 2.21 the user can now link up to eight remote devices / functions to the

AD1200. After entering

Press: PROG

Enter one of the eight Remote Device locations (1 ... 8)

The user has 4s time to activate the remote device and link it to the AD1200.

Note: If the selected location already contains another Remote Device the current location

must be deleted first (refer to 2.23) before linking a new device is possible at this location.

To delete a Remote Device follow the following procedure:

Press: PROG

Enter one of the eight Remote Device locations (1 ... 8)

Wait for approximately 4s until an acknowledge sound is played. While this period of time do not

activate any Remote Device. Now the selected location is deleted.

To delete all eight possible Remote Devices enter the following:

Press: PROG

AD1200 Installer Manual, Rev. 19.06.2013

Press:

PROG

ENTER