DTAR Multi-Source Руководство - Страница 5

Просмотреть онлайн или скачать pdf Руководство для Микрофонная система DTAR Multi-Source. DTAR Multi-Source 8 страниц. Pickup and microphone system

Converting the output signal to stereo operation

To reconfigure the Wave-Length Multi-Source for

stereo output, follow these steps:

1. Look inside the guitar and find the cable clamps

that secure the pickup lead wire, battery wires and Control

Module cables going to the preamp chassis. Loosen only

the cable clamps necessary to allow the preamp chassis

to be moved as far as the sound hole. Do not attempt to

remove the adhesive backed clamps from the guitar; you

only need to un-bend them slightly so the cable cables

can be moved.

2. Remove the strap button and outer nut and washer from

the endpin jack. Keep this hardware in a safe place so you

will not lose it.

3. Carefully slide the endpin/chassis assembly free from the

end block of the guitar and move it into view from the

sound hole. Do not apply any stress to the any of the cable

attached to the preamp, especially the pickup cable.

4. Remove the two small screws that secure the chassis top

to the sides. Put the top and screws with the other

hardware.

5. Refer to figure 1 (on page 6). If you have the original style

product, it will be necessary to cut or remove the small

wire jumper indicated and resolder a jumper from the center

connection point to the left connection point. If you have the