Attonic FG1 Руководство по эксплуатации - Страница 12

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Измерительные приборы Attonic FG1. Attonic FG1 20 страниц. Digital force gauge

7-7.Set flipping screen DP (Initial Setting: OFF)

・It is a setting to flip the screen.

For example, when measuring with the detection shaft facing up, the values are reversed and difficult to

read, but by turning on this setting, the values can be read as they are.

* You can switch ON / OFF repeatedly by pressing the "DAT" switch.

* Short press the "FUN" switch to confirm the setting. Next is the setting for auto power off.

7-8.Set auto power off　 AF　（Initial Setting: ON）

・It is a setting to turn off the power if no operation is performed for 10 minutes.

　 Turn this setting OFF if you want to use the gauge for a long time.

　 The measurement will remain until the battery runs out.

* You can switch ON / OFF repeatedly by pressing the "DAT" switch.

* Short press the "FUN" switch to confirm the setting. Next is the setting for auto reset.

7-9.Set auto reset 　AC　 (Initial Setting: OFF)

・ It is a setting to automatically reset after 3 seconds when the load disappears.

You don't have to press the reset button every time you run the same test over and over again.

* When reset, the data will be saved automatically.

* Work efficiency will increase when used in combination with printer output.

* You can switch ON / OFF repeatedly by pressing the "DAT" switch.

* Short press the "FUN" switch to confirm the setting. Next is the setting for the minimum digit display.

7-10.Set the minimum digit display　MD　(Initial Setting: ON)

・Set whether to display the minimum digit or not.

The display looks more stable when the minimum digit is not displayed (OFF).

* The display range varies depending on the model. For the display range, refer to the display range table.

* You can switch ON / OFF repeatedly by pressing the "DAT" switch.

* Short press the "FUN" switch to confirm the setting. Next is the setting for buzzer.

The display changes every time the

"DAT" switch is pressed.

The display changes every time

the "DAT" switch is pressed.

The display changes every time

the "DAT" switch is pressed.

The display changes every time

the "DAT" switch is pressed.