Attwood 91020 Инструкции по установке

Просмотреть онлайн или скачать pdf Инструкции по установке для Морское освещение Attwood 91020. Attwood 91020 2 страницы. Attwood plastic stowaway light base installation instructions

Печатать страницу

Plastic Stowaway Light Base

91020, 91022 (2 wire)

91021 (3 wire)

Installation Instructions

Attwood marine hardware, navigational lighting, bilge pumps, and

other marine accessories are specified more than any other brand by

America's best-known boat manufacturers as original equipment.

Look to Attwood for quality replacement parts and marine accessories.

SAVE THESE INSTRUCTIONS

Form Number 69345 Rev. C

FEATURES

This base is designed for use with the Attwood 3900 Series All-

Round Lights And Attwood Combination Sidelights.

For 12-volt D.C. only.

CAUTION

To prevent personal injury, always disconnect the power source

when installing or servicing this product. Always remove the boat

from the water before using 120 VAC power tools.

INSTALLATION INSTRUCTIONS

Note: For technical detailed positioning follow COLREG 72 or ABYC

A-16. Below is a simplified drawing of placement of navigational

lights in relationship to one another. (Figure 1)

Figure 1

1. Position the light base either on the bow for combination sidelights

or the stern or gunwale for all-round lights. Be sure that the

mounting surface is flat and that the selected area will accommo-

date the base dimensions. Base angle and position must properly

place light used in base.

2. Using the template provided, locate the base center line parallel

to the boat fore-and-aft center line and carefully mark the center

installation hole and the screw holes. Drill 1-3/8'' diameter hole for

#91022 or 1-1/4" diameter hole for #91020 and #91021 being very

careful not to crack or break the gelcoat finish, and sand to remove

burrs from around the edge of the hole. Drill the pilot screw holes.

(Figure 2)

Note: On some installations you may have to connect the wires then

push them back through wire hole prior to screwing down the base.

3. Apply sealant between deck and light base. Fasten base in place

with stainless steel screws.

CAUTION

Do not overtighten screws.

Figure 2

03-12

1-3/4"

Oval Template

1-1/4"

Round Template

3/4"

15/32"

15/16"

Forward

1-1/2"

3/4"

Forward

1-3/8"

27/32"

1-1/4"