DTG M2 Руководство по замене - Страница 3

Просмотреть онлайн или скачать pdf Руководство по замене для Принтер DTG M2. DTG M2 8 страниц. Printhead cable replacement

M2 (PRINTHEAD CABLE REPLACEMENT)

(Always POWER DOWN printer and UNPLUG before doing any repair work)

7. Gently pull the printhead out of the carriage. Be careful where you pull from, it's best to use the

area indicated below . Sometimes it will require both hands to get the head out. Usually pushing

back, then lifting up, wiggling the head as you are lifting up.

Notice the

adjustment screw

do not want to adjust this screw. It's best to work around it when replacing the printhead.

WARNING:

Becareful not to damage the "FACE" of your printhead while installing the new one. NEVER touch the face of

the printhead or lay it face down on anything.

Fig 1-E

ADJUSTMENT SCREW

Place your fingers in the areas indicated (along the

walls on bothe sides of dampers recievers) . It might

take both hands.

8. Pull the FFC cables straight out, be careful not to damage the "Teeth" on the cables.

(Indicated in 1-F and 1-G)

Fig 1-F

Pull FFC cables straight out, be

careful not to damage "teeth"

Revision Date / Version: 2/13/2014 - 7

, this screw has been factory set to keep the printhead tilt correct. We

Fig 1-G

Pull FFC cables straight out, be

careful not to damage "teeth"