DTM System DTM GO800 Инструкция по сборке Руководство - Страница 5
Просмотреть онлайн или скачать pdf Инструкция по сборке Руководство для Открыватель двери гаража DTM System DTM GO800. DTM System DTM GO800 12 страниц.
Печатать страницу1. Introduction
1.1General information
The DTM System electromechanical drive is designed to automate garage doors. The assembled and
launched system can be conveniently operated by radio transmitters (remote controls).
1.2. Technical data
power supply
•
current consumption / at rest
•
protection class
•
maximum gate movement speed:
•
maximum drawbar pull:
•
work intensity
•
temperature range
•
built-in lighting / lighting time
•
length of the running rail with drive and handle: 3440 mm, folded from elements, with toothed belt
•
maximum stroke of the trolley:
•
maximum door width:
•
maximum door area of
•
automation control
•
input for safety devices
•
accessories power output:
•
operating modes:
•
photo input operating modes:
•
retraction of the trolley after closing:
•
1.3 Mechanical components
Before starting work, check if all the elements shown in fig. 1 are present, and then read the entire
manual.
2. MECHANICAL ASSEMBLY
2.1. Verification of the type and structure of the gate
In order to properly complete and install the automation system, verify the type of your gate and check
the structure of the existing or installed gate against the requirements set out below:
7
10
8
9
4xM6
Part definition:
1 drive head with lighting;
2a a C-shaped rail together with a toothed drive belt;
2b "C" shaped rail with holes;
2c "C" shaped rail;
3 slip-on connectors, 2 pieces;
4 carriage and emergency release locking mechanism;
5 remote control transmitter
6 ceiling hanger;
7 pin and securing pin, bolt and tension spring;
8 front piece;
9 a tension element;
10 cart-gate pusher;
11 gate hardware;
Fig. 1. Necessary mechanical elements.
230 VAC / 50Hz
1A / 0.04 A
IP-20
125 mm / s
800N
15% (9 cycles / h)
-20 ° C to + 50 ° C
permanent LED / 4min.
2650mm
5000 mm
12.6 m2
wall button / radio remote controls
yes, photo input
yes, + 24VDC max. 100mA
open, close, step by step, close after time, airing
stop, reverse when closing or closing and opening
yes, 1-5mm
1
11
2a
2b
2c
3
6
2x
5
4
4xM6
5
6
2x