Aube Technologies TI035 Руководство по установке и эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Переключатель Aube Technologies TI035. Aube Technologies TI035 13 страниц. Programmable wall switch
Также для Aube Technologies TI035: Руководство по установке и эксплуатации (4 страниц)
Печатать страницу
Troubleshooting
Blank display
Faded or irregular
display
Cannot switch between 24-hour format
and 12-hour format
Programs do not run as expected
The switch resets itself without apparent
reason when used to control an inductive
load such as a relay or a contactor.
After I have bypassed the program to turn
the light Off, it turns back On at midnight.
Warranty
Honeywell warrants this product, excluding battery, to be free from defects in the workmanship or materials, under normal
use and service, for a period of three (3) years from the date of purchase by the consumer. If at any time during the
warranty period the product is determined to be defective or malfunctions, Honeywell shall repair or replace it (at
Honeywell's option).
If the product is defective,
(i) return it, with a bill of sale or other dated proof of purchase, to the place from which you purchased it, or
(ii) contact Honeywell. Honeywell will make the determination whether the product should be returned, or whether a
replacement product can be sent to you.
This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it is shown by Honeywell that
the defect or malfunction was caused by damage which occurred while the product was in the possession of a consumer.
Honeywell's sole responsibility shall be to repair or replace the product within the terms stated above. HONEYWELL
SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY,
EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT. Some provinces, states or regions do not allow
the exclusion or limitation of incidental or consequential damages, so this limitation may not apply to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY HONEYWELL MAKES ON THIS PRODUCT. THE DURATION
OF ANY IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, IS HEREBY LIMITED TO THE THREE-YEAR DURATION OF THIS WARRANTY. Some
provinces, states or regions do not allow limitations on how long an implied warranty lasts, so the above limitation may not
apply to you.
This warranty gives you specific legal rights, and you may have other rights which vary from one province, state or region to
another.
Customer Assistance
If you have any questions about your light switch, go to
http://www.aubetech.com, send an email to [email protected] or
call Aube/Honeywell Customer Care toll-free at 1-800-831-2823.
• Verify circuit breaker at main panel.
• Ensure the ON/OFF selector is at ON.
• Reset the switch using a paper clip.
Ambient temperature below freezing point
First, press one of the control buttons so that MAN or
AUTO appears on display.
• Make sure the switch is properly programmed.
• Note that - : - - indicates an inactive program.
• If the switch has been configured for 12-hour format,
check that PM appears on the left side of the screen
when an afternoon time is displayed.
The reset is caused by the load. Install a snubber
(AC130-03) at each relay/contactor.
Any temporary override (bypass) is cancelled at midnight.
If you have programmed the switch to turn the light off
after midnight and then you manually turn the light off
before midnight, this is an override. The override will be
cancelled at midnight and the light will turn back on. To
ensure that the light remains Off when you bypass
programming, set P1 OFF to midnight or earlier.
5/6