Auber Instruments WS Series Краткое руководство - Страница 2

Просмотреть онлайн или скачать pdf Краткое руководство для Контроллер температуры Auber Instruments WS Series. Auber Instruments WS Series 14 страниц. Programmable pid temperature controller with dual probe
Также для Auber Instruments WS Series: Краткое руководство (15 страниц), Краткое руководство (14 страниц), Руководство по эксплуатации и инструкция (18 страниц), Руководство по эксплуатации и инструкция (18 страниц)

Instruments only. Using it to control a non-recommended device can be

dangerous and cause fire. Auber Instruments is not liable for damages caused by

misuse of the controller. If you are not sure the controller can be used, please

contact Auber Instruments before use.

 If an abnormal display or noise is observed, turn the controller off, unplug the

power cord and contact the manufacturer before using it again.

 Clean the controller only when it is cool and unplugged.

 Do not allow children to operate the controller.

Operating Instructions

1. Description of the controller.

1) TEMP1, Left window - During normal operation, it displays the temperature values

of probe 1. When the high or low limit alarm of probe 1 is on, this window will flash

between the alarm type (AH1or AL1) and the temperature. In the parameter setting

mode, it displays the controller's system parameters.

2) TEMP2/TIME, Right window - During normal operation, it displays the

temperature value of probe 2 (food internal temperature probe) or the time passed

since the controller was powered up. When the high limit alarm of probe 2 is on,

this window will flash between AH2 and the temperature. In the parameter setting

mode, it displays the value of the parameter.

3) Output status indicator - This LED indicates the output status that should be

synchronized with the heater. When it is on (lit), the heater is powered. When it is

off, the heater power is off. When it is flashing, it means the heater is on and off

intermittently to reduce the power output. It should be synchronized with the power

light on the cooking device.

Figure 1. Front Panel