CON-TEC DLUX 30 N++ Руководство
Просмотреть онлайн или скачать pdf Руководство для Аксессуары для велосипедов CON-TEC DLUX 30 N++. CON-TEC DLUX 30 N++ 2 страницы. Bike led front light
Печатать страницу
Manual
Bike LED Front Light
DLUX 30 N++ / DLUX 50 N++
Congratulations on the purchase of your new device. The user's manual is part of this device and
contains important information to safety, installation and disposal. Familiarize yourself with all operating
and safety instructions before using the device. Use the device as described and in the specified areas of
application. Keep this manual in a safe place and hand it with you when distributing the device.
Used symbols
Green Point – Recycling the packaging
Symbol for the detection of electrical and electronic devices
Test mark of the Federal Motor Transport Authority (K with
K XXXX
the following approval number)
Proper use
The product is intended for use on bicycles with pedal assistance and serves the illumination of the
road. This LED front light is approved according to the currently valid RTLR (StVZO). The product is
intended for outdoor use.
Safety information
- Do not look into the LEDs of the front
- Do not point the LED front light directly at people or animals.
- The light beam of the LED front light must point straight in direction.
- The light distribution may be obscured by no other attached parts or pieces of luggage, not even
partially.
- The LEDs are not interchangeable. If the LED fails, the entire luminaire must be replaced.
- The front light or the rear light may only be mounted on bicycles with an AC power supply
- Please note that the DC version may only be used on bicycles with electric pedal assistance. If,
after the support drive has been turned off due to discharge
- an uninterrupted power supply to the lighting system is still ensured for at least two hours after
the support drive has been turned off due to discharge, or if the drive motor can be used as an
alternator on a transitional basis in order to continue to supply power to the lighting system.
Safety information
WARNING! LIFE AND ACCIDENT HAZARD FOR INFANTS AND CHILDREN!
Never leave children unattended with the packaging material, because of suffocation danger by
swallowing packaging parts. Always keep the device away from children. The device is not a toy!
This device can be used by children of age 8 and over and by persons with reduced physical or
mental capabilities or lack of experience and knowledge if they have been supervised or instructed
concerning the safe use of the device and by understanding resulting hazards. Children are not
allowed to play with the device. Cleaning and user maintenance should not be carried out by
children without supervision. Do not disassemble the device. Improper repairs can cause
significant risks for the user. Only have repairing made by qualified personnel.
Manual_DLUX 30/50
Mapped components
Front light
1
Integrated reflector
2
3
Connecting cable on the electrical bike system
4. Adjusting screw for height adjustment
Front light bracket
5
Connecting cable for rear light connection
Sensor for ambient light
Front light with holding backet and reflector
1
4
2
3
LED Front light assembly
Front light (1) mount to the steel bracket and make sure that the front light (1) cannot be adjust by itself
(tighten the screw firmly enough!)
Connection to the electric system
5
A pair of cables (longer) (3) for connecting to the dynamo is located at the bottom of the front light (1).
The pair of cables can be cut if necessary. The second (shorter) pair of cables is for connection to the
rear light wiring. If a dynamo-rear light is used, it must be connected to the front light. If there is no
cable from the rear light, it can be made with an extension cable (specialized trade). The front light can
basically be connected to both hub and side-running dynamos that produce 6V.
Attention: If the front light is connected to a side-running dynamo, the dynamo's drive wheel must be in
continuous contact with the tire for proper working.
Attention: Always pay attention to the correct polarity. Never completely break the front light cable. The
electrical connection may only be made by a qualified electrician.
Black cable = power
Black-white cable = earth