CON-TEC DLUX micro 40 Руководство по эксплуатации

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Аксессуары для велосипедов CON-TEC DLUX micro 40. CON-TEC DLUX micro 40 2 страницы. Led battery light set

Печатать страницу

Instruction manual bike

LED battery light set

DLUX micro 40

Scope of delivery

• battery front light

• handlebar bracket

• insert for Ø 25-30mm

• insert for Ø 30-35mm

adapter cable USB-C to USB-A

adapter cable micro-USB to USB-A

General notes

Proper use

The product is intended for use on bicycles with pedal assistance and serves the illumination of the road.

This LED front light is approved according to the currently valid RTLR (StVZO). The product is intended for

outdoor use.

Safety instructions

- Do not look into the light.

- Do not point the light directly at people or animals.

- The light beam of the LED front light must point straight in direction and may not blind other road users.

- The light distribution may be obscured by no other attached parts or pieces of luggage, not even partially.

- The LEDs are not interchangeable. If the LED fails, the entire luminaire must be replaced.

WARNING! LIFE AND ACCIDENT HAZARD FOR INFANTS AND CHILDREN!

Never leave children unattended with the packaging material, because of suffocation danger by

swallowing packaging parts. Always keep the device away from children. The device is not a toy! This

device can be used by children of age 8 and over and by persons with reduced physical or mental

capabilities or lack of experience and knowledge if they have been supervised or instructed concerning

the safe use of the device and by understanding resulting hazards. Children are not allowed to play with

the device. Cleaning and user maintenance should not be carried out by children without supervision.

Do not disassemble the device. Improper repairs can cause significant risks for the user. Only have

repairing made by qualified personnel.

Manual_DLUX micro 40

Assembly / disassembly

Handlebar bracket

Preparation: select suitable insert (Ø 25-30mm or Ø 30-35mm)

on the basis of the given handlebar size and insert into the

handlebar clamp

Place clamp around handlebar and hook in grip nut

Tighten the handle nut

Front Lights

asseembly

1. Put on the front headlight on rear edge of bracket

2. Press down until the front headlight engages in

the clamp bracket

• battery rear light

• mounting clip

• rubber straps

Alignment

Align the LED front light so that the light beam reaches the road approx. 10 meters in front of the wheel (see ill.). The

light beam of the LED front light must point straight in direction from 400 up to 1200mm.

Centering

Attention!

Check regularly the correct setting of your front light.

disassembly

1. Press release button on underside and

remove front headlamp (2.)

Inclination

Operation

Switch on/off

To switch on and off, press and hold the button for 2 seconds each time.

Brightness levels

The front headlight has 4 selectable brightness level. The activation of the next brighter

level is achieved by a short push of the button.The highest brightness level is followed

by the lowest brightness level again.

Brightness levels indicator

Brightness levels

The two brightness levels are indicated by different colored lights of the LED ring.

Low battery mode

From a remaining battery capacity of 4%, the front headlight limits the brightness to level 1. The

lowest LED of the battery status indicator flashes red.

Temperature monitoring

If the lamp head overheats, the front light limits the brightness to level 1 until the normal operating

temperature is reached again.

Charging

The internal battery of the rear light is charged by a USB voltage source. The supplied adapter cable is

plugged into the micro-USB socket on the bottom of the rear light.

micro-USB socket