daltile 1020 TS Руководство по эксплуатации - Страница 12
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Пила daltile 1020 TS. daltile 1020 TS 16 страниц. Tile
Печатать страницуUNPACKING AND SETTING UP
Unpacking and Assembly
Unpack the tile saw and inspect
for any damaged parts.
Install the legs in the sockets at the under
side of the water container and fasten with
the knobs. Markings show the right
position.`The wheels on the hind legs
should face outward.
Level the tile saw by adjusting the
legs in the sockets and make sure its
stable.
Release the transportation lock.
Setting the Cutting Depth:
When loosening the Cutting Head
Adjusting Knob, the Cutting Head will
pivot down unless held.
Loosen Cutting Head Adjusting Knob
Set cutting depth approximately 1/4 inch
below the surface of the Movable Cutting
Table
Ensure the Adjusting Knob is tight
PAGE 12 DALTILE 1020TS OPERATING MANUAL V02/2004R1
Transportation Lock
Adjustable Cutting Depth
Stop.
The adjustable stop is pre-set for a 10 inch
blade to prevent cutting into the Movable
Cutting Table.
When using smaller blades, the stop can be
adjusted to a cutting depth approximately 1/4
inch below the surface of the Movable Cutting
Table.
Cooling system
Operating the water pump without a sufficient
supply of water may result in pump damage.
Place the plug in the drain of the water
container.
Fill the container with water until the
water pump is completely submerged.
Connecting to power supply
Before connecting the machine make sure that:
the line voltage corresponds with the data
on the machine's specifications plate,
there is a grounded power supply,
the extension cord's meets criterea as
mentioned in the table on page 10.