Conair 17 PIECE HC117WCSC Инструкции по уходу и использованию - Страница 7
Просмотреть онлайн или скачать pdf Инструкции по уходу и использованию для Электрическая бритва Conair 17 PIECE HC117WCSC. Conair 17 PIECE HC117WCSC 8 страниц.
Печатать страницу
comb must cover or be to the extreme left
hand of the first small tooth of the cutter.
*Be sure that the extreme right hand big
tooth of the cutter touches the extreme right
hand tooth of the cutting comb.
Any other servicing should be performed by
an authorized service representative or that
the appliance has no user serviceable parts.
The product is for household use.
Do not pull, twist, or wrap line cord
around appliance.
SPECIAL OIL
To maintain the blades of your Conair
clipper, oil them after every three or four
haircuts. Gently place a few drops of oil on
the teeth of the blades, using the special
®
Conair
oil included with your set. Turn
the clipper on for a minute, then turn off.
This light, natural oil was formulated
specifically for the Conair
clipper. Because it is the right oil to use, it
will not slow down the blades. Never use
any other product. There is no substitute
for Conair oil.
POWER SCREW
The power screw permits you to adjust
the power of your clipper. You may need
to adjust it if the power in your house is
low. (The Conair
for household use.)
®
high-speed
®
clipper was designed
1. With screwdriver or dime, turn the
power screw clockwise until arm strikes
the coil, making a clacking noise. FIG. 3
2. Then turn the screw counterclockwise,
just until noise stops. This is the
maximum power setting. FIG. 4
®
ADJUSTABLE TAPER LEVER
Just like professional clippers, the Conair
taper lever is positioned at your thumb.
You can hold the clipper in your hand and
adjust the lever at the same time...while
you're clipping.
This taper lever eliminates the need for an
attachment comb because it lets you
gradually adjust the closeness of the cut.
For the closest cut and the shortest hair,
push taper lever up as far as it will go. To
increase cutting length, slowly push lever
down. If you push to the lowest position, it
will leave hair about the same length as the
short attachment.
FIG. 3
FIG. 4