Conair 20-piece HC200WXCSC Инструкции по уходу и использованию - Страница 10
Просмотреть онлайн или скачать pdf Инструкции по уходу и использованию для Электрическая бритва Conair 20-piece HC200WXCSC. Conair 20-piece HC200WXCSC 17 страниц. Haircut kit
Печатать страницу
USER-MAINTENANCE
INSTRUCTIONS
CARE OF YOUR CLIPPERS
IF YOU DETERMINE THAT BLADE
ALIGNMENT IS INCORRECT:
MAINTENANCE OF THE BLADE
Always apply oil to the blades before, during
and after use. This will ensure
maximum
cutting performance. Hold clipper away from
your body in a downward position and apply oil
on the front and sides of the cutter blade. Wipe
excess oil off with a soft dry cloth.
Conair
®
hair clippers are carefully inspected to
insure that the blades are in perfect alignment.
You will need to realign the blades after
removing them for cleaning or replacement, or
if they should be knocked out of alignment. How
can you tell if the blades need realigning?
Simply match them up, point for point, to
confirm with the drawing below.
To replace cutting comb and cutter after
removal for cleaning, replacement or, because
they are out of alignment, slide the cutter back
on to the black plastic oscillating head. Next,
you must make sure that the cutter (small
blade) and the cutting comb (large blade) are
properly aligned. Line up the new or existing
cutting comb with the two screw holes. Place
the original screws, one in each hole, and
lightly tighten with a Phillips head screwdriver.
*The top edge of the cutting comb should be
1/32" to 1/16" (.79 mm. to 1.59 mm.) higher
than the top edge of the cutter. This is important
so that the clipper does not cut too close, or
come in contact with the skin.