DAMPP-CHASER Piano Life Saver System Руководство по установке - Страница 6

Просмотреть онлайн или скачать pdf Руководство по установке для Шпилечный датчик DAMPP-CHASER Piano Life Saver System. DAMPP-CHASER Piano Life Saver System 9 страниц. Backside vertical 8-part system which includes two humidifiers
Также для DAMPP-CHASER Piano Life Saver System: Инструкции по установке (4 страниц), Руководство по установке (8 страниц), Инструкции по уходу и обслуживанию (2 страниц)

Ideally, the lower corner of the Humidistat should be positioned

5 cm above the top of the Humidifier tank and 5 cm away from

the side of the Humidifier tank (Figure 14). With a suspended

tank, the Humidistat should also be positioned approximately

5 cm above and 5 cm from the side of the tank.

Now, plug the Dehumidifier and the Humidifier into the Humi-

distat. Make sure you do not put the plugs into the wrong

outlets. Connect the separate 3 m extension power cord to the

Humidistat outlet which is below the DEHUMIDIFIER outlet.

Then, route this Humidistat power cord out of the piano. First

run the 3 m cord to the treble end. Then run it up beside the

action and out the lid (Figure 15). From there the cord goes

down to an electrical outlet. With experience you will develop

your own technique for bringing the cord out under the lid. The

6 mm clamps may be used to attach the cord to the inside of

the piano.

FIGURE 14

Typical

Humidistat position

Dehumidifier

Power cord to

electrical outlet

You may prefer another method of running the power cord out

of the piano. If you feel comfortable drilling a hole in the

bottom board, you can bring the power cord out through the

hole (Figure 16). To provide strain relief for the cord, knot it

and secure the knot to an appropriate wood area with one of

the 6 mm clamps provided.

From the Humidifier tank, take the white cord, with the tele-

phone jack adaptor, and plug it into the Humidistat outlet

marked WATER SENSOR (Figure 17). Plug the Smart

Bracket's phono jack adaptor into the outlet marked

SB/PADS. Using wire ties and cable ties, neatly rebundle

excess cords for the Dehumidifier, Humidifier, Water Sensor

and Smart Bracket.

FIGURE 15

Routing the power cord

out of the piano

FIGURE 16

Alternate method for running

power cord out of piano

FIGURE 17

Humidifier

Heater

Bar