DAMPP-CHASER Piano Life Saver System Руководство по установке - Страница 6
Просмотреть онлайн или скачать pdf Руководство по установке для Шпилечный датчик DAMPP-CHASER Piano Life Saver System. DAMPP-CHASER Piano Life Saver System 8 страниц. Backside vertical 8-part system which includes two humidifiers
Также для DAMPP-CHASER Piano Life Saver System: Инструкции по установке (4 страниц), Руководство по установке (9 страниц), Инструкции по уходу и обслуживанию (2 страниц)
Печатать страницу
from the baseboard and also clean the baseboard where the
Humidifier rests. When dry, remove the white backing from the
Velcro attached to the Humidifier (3 pieces) and place the
Humidifier in the center of the bay. The white foam on the
Humidifiers faces the piano. Attach the Velcro on the sides of
the Humidifier with the exposed adhesive to the beams. Repeat
this procedure with the second Humidifier. Insert the tube in the
supporting C-Clips on the beams.
The Humidifier Heater Bar with the Smart Bracket should be
mounted on the Humidifier which is located at the treble end of
the piano. Attach the cords from both Humidifier Heater Bars to
the white extension cord. Run the cut end of the white
extension cord through the hole previously drilled in the bottom
board. Connect a Super Plug to the cut end of the white
HUMIDIFIER cord in the inside of the piano (Figure 11). Plug
this Humidifier cord into the HUMIDIFIER outlet on the
Humidistat inside the piano. Run the Smart Bracket cord (from
the treble end Humidifier Heater Bar) and the Low Water
Sensor cord through the hole and attach the jacks in the
appropriate outlets on the bottom of the Humidistat (Figure 12).
To open, use fingernail
to pull metal spring
Brown Extension
Cord with Super
Plug (from
Dehumidifiers)
Pin Pegs
Velcro
Pin pegs in Baffle
Use Velcro on metal surfaces
instead of pin pegs
Place wire from heater bar in
groove. Be sure it lies flat
back.
Velcro
FIGURE 13
STEP 4. BAFFLE INSTALLATION
Install the moisture distribution Baffles above the Humidifiers
between and at the top of the bays as shown in Figure 8,
page 5. Properly installed, the Baffle should resemble a small
roof. The Baffle is attached to the piano with two pin pegs
pushed through the top of the Baffle roof, one at each end, into
the wood of the piano (Figure 13). Use Velcro to mount the
Baffle where you encounter a metal surface.
STEP 5. DEHUMIDIFIER INSTALLATION
Three 18-inch Dehumidifiers are provided. The Dehumidifiers
must be installed with the cords at the lower end. Notice the
placement of the Dehumidifiers in Figure 8, page 5. Six angle
brackets are used to mount the Dehumidifiers (Figure 14). The
angle brackets are bent to fit 9-inch wide bays. You can bend
them more, if necessary, to fit the bays on the piano. Just be
careful not to break the rivet holding the clip to the bracket.
Mount an angle bracket to secure each Dehumidifier at both
ends. Use the 1/2-inch screws to attach the angle brackets to
the beams.
without twist.
FIGURE 11
Super Plug
FIGURE 12
Pin Peg
6
To close, press hard until
spring snaps shut. Pliers
work great.
White Extension
Cord with Super
Plug (from
Humidifier
Heater Bars)
Angle Bracket
FIGURE 14