ADDER ADDERLink INFINITY 101T Быстрый старт

Просмотреть онлайн или скачать pdf Быстрый старт для Удлинитель ADDER ADDERLink INFINITY 101T. ADDER ADDERLink INFINITY 101T 2 страницы.

www.adder.com

Part No. MAN-QS-ALIF101T-ADDER_V1.0

ADDERLink INFINITY 101T

Welcome

This quick start guide covers some of the key points of the ALIF101T unit. Full user details and setup

instructions can be found at www.adder.com/en/kvm-solutions/adderlink-infinity-101t

Initial configuration

Please see the next page for Connection details.

ALIF units can be linked in two mains ways: Direct or Networked.

Direct linking

Where ALIF transmitters and receivers are directly linked to each other, very little configuration action

is required, provided that they both have their factory default settings in place - just link them together.

If the standard settings have been changed in a previous installation, you merely need to perform a

manual factory reset on each unit. Please see the next page for further details.

ALIF101T

Networked linking

Where ALIF units are connected via networked links, you can either configure them individually, or

configure them collectively using an AIM server:

• Configuring networked ALIF units individually - You need to specify the network addresses

of the ALIF units so that they can locate each other. This is done by running the ADDERLink

INFINITY browser-based configuration utility on a computer system linked to the same network

as the ALIF units. Please see the next page for further details.

• Configuring networked ALIF units collectively - The ADDERLink INFINITY Management

(AIM) server allows you to configure, control and coordinate any number of ALIF transmitters and

receivers from a single application. See adder.com for details.

Note: If you are using one or more ALIF101T transmitters

within an installation managed by an AIM server, the AIM

server must be running firmware version 4.12 or above.

Gigabit

ALIF101T

Ethernet

IMPORTANT: When using AIM to configure ALIF units, it is

vital that all units that you wish to locate and control are

set to their factory default settings. Otherwise they will

not be located by the AIM server. If necessary, perform a

manual factory reset on each ALIF unit. See next page.

Quick Start

ALIF RX

continued overleaf