Conairphone CID100 Руководство пользователя - Страница 3
Просмотреть онлайн или скачать pdf Руководство пользователя для Беспроводной телефон Conairphone CID100. Conairphone CID100 7 страниц. Caller id big button telephone with 10 memory dialing
Печатать страницуLOCATION OF CONTROLS
1
2
3
4
5
6
7
8
9
10
1. Ringer Hi/Lo/Off Switch
9. Transmitter
2. Receiver
10. Mem Button
3. Receiver Volume Control
11. New Call LED
4. Hook Switch
12. LCD Display
5. Keypad
13. Review
6. Tone/Pulse Switch
14. Battery Compartment
7. Redial Button
15. Erase Button
8. Store Button
16. Call Back Button
4
CONGRATULATIONS!
You have purchased a CID100, 10-Memory Caller ID Telephone
manufactured to the highest standards of Conairphone
installing and operating, be sure to read this manual.
GENERAL INFORMATION
UNPACKING
This package contains:
• CID100 Telephone with Caller ID
11
• Owner's Manual
12
• One (1) Fully Modular Coil Cord
• One (1) Fully Modular Telephone Line Cord (Long Straight
13
Cord)
• One (1) Fully Modular Telephone Line Cord (Short Straight
14
Cord)
15
• One (1) Quick Installation Guide
16
• One (1) Important Notice
• One (1) Safety Instructions for Batteries
• One (1) Additional Memory Index Label
• Warranty Card (Part of the Owner's Manual)
If anything is missing or damaged, contact the place of purchase.
Keep the packaging to transport telephone.
For your reference, keep a record of the date purchased.
Please save the sales receipt for the warranty reference.
Date of Purchase ___________________________
/
Button
INSTALLATION INSTRUCTIONS
Follow these precautions:
a. Never install telephone wiring during a lightning storm.
b. Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
c. Never touch uninsulated telephone wires or terminals unless
the incoming telephone line has been disconnected at the
network interface.
d. Use caution when installing or modifying telephone lines.
TM
. Before
5
TO INSTALL BATTERIES
Batteries are required for the Caller ID functions and Telephone
operations of the unit.
1. Open the battery door by pulling back the latch.
2. Insert four (4) AAA alkaline batteries (not included).
3. Snap the battery door back into place.
SETTING UP YOUR CID100
DO NOT CONNECT the line cord to the wall outlet until the
Caller ID setup has been completed.
The LCD shows 'ENTER LANGUAGE'
followed by a choice of 3 languages
(English, Spanish, French). If your
display does not appear this way, press and hold both [ ] and
[ ] for 4 seconds.
The LCD then shows 'ENG ESP FRA'.
NOTE: The 'ENG' is BLINKING. Press
[ ] or [ ] to select 'ENG', 'ESP', or 'FRA'.
Press [ERASE] to confirm.
If ENG is selected, the LCD shows 'LCD
CONTRAST'.
Press [ ] or [ ] to adjust five levels (from
1 to 5, default is 3) contrast of LCD.
Press [ERASE] to confirm.
If contrast is set, the LCD shows
'ENTER AREA CODE'. The first digit
'–' of the area code will blink.
Press [ ] or [ ] to enter the area code. Press [ERASE] to confirm
and go to next entry.
Repeat above steps until 3-digit area code is set.
6