Elite ELITE B 20 Книга инструкций - Страница 12
Просмотреть онлайн или скачать pdf Книга инструкций для Внутренняя отделка Elite ELITE B 20. Elite ELITE B 20 19 страниц. Drill grinding machine up to o 20 mm.
Печатать страницу
To change the grinding wheel, disconnect the machine
from the power supply.
Open the two screws 1 and 2 of the guard with a 10 mm spanner. Remove the grinding
wheel guard.
Loosen the hexagonal screw with a 4 mm Allen key. Turn the screw until the grinding wheel
can be removed with the grinding wheel holder.
Insert the new grinding wheel into the motor shaft and tighten the screw again, then tighten
the grinding wheel guard. Check that the grinding wheel is correctly mounted.
Grinding wheels must conform to EN 12413 or EN 13236. After changing the grinding wheel,
carry out a 1-minute test run with the motor running. If the grinding wheel does not work
properly, switch it off and look for the reason for the malfunction.
Never use the machine without the grinding wheel cover
installed.
Joan Oró, 27. Pol. Ind. Sesrovires, St. Esteve Sesrovires, BCN, Spain– Tel: +34 932 935 178 – [email protected]
Grinding wheel replacement
12