Airuno Aida 60 Инструкции по установке и эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Инструкции по установке и эксплуатации для Вентиляционная вытяжка Airuno Aida 60. Airuno Aida 60 12 страниц. Built-in cupboard hood

Печатать страницу

Before cleaning or performing any periodic or

urgent maintenance to the hood, isolate the

mains supply and turn the main switch off.

Do not connect the hood to any piping used for

combustion appliances, such as burners, boilers

or fire places.

Check that the main power supply corresponds

to the voltage required by the hood, which is

given on the silver label stuck inside the hood.

Ensure that the electric system is correctly

earthed and that the earth discharge works

correctly.

When cooking do not use any materials that

could form high or unusual flames. Oil that has

been used twice and fats are very dangerous

and could easily catch fire. Do not prepare

flambé dishes under the hood.

Once the specialised technician has completed

the installation of the hood equipped with a

remote motor, all the leads, connectors, ground

connections and the remote motor must not be

accessible to the user. Only the installer is

granted access by removing screwed on panel.

Respect local legislation and regulations issued

by the relative authorities regarding the exhaust

air when the suction is operating. Failure to

respect and perform all maintenance and

cleaning operations described in this handbook

could cause a fire hazard.

ATTENTION: Accessible parts may become hot when

the hood is used with cooking appliance.

3. Installation

The minimum safety distance between the bottom of

the hood and the top of the cooking hob must be

650mm (Fig 1), smaller distances must be previously

authorised by the manufacturer.

Ø150mm round or 220x90mm rectangular ducting

must be used. Ducting with a smaller diameter could

cause airflow issues.

The hood can be used for both filtering and suction.

When the filtering function is operating, i.e. with air

recycle, carbon filters must be used (refer to the

paragraph on Carbon Filters page 9).

When the suction function is operating i.e. exhausting

the filtered air on the outside, a suitable

compensation system must be used according to

current standards in force. The diameter of the fume

exhaust pipe must be the same or greater than the

diameter of the hood pipe union.

There must be sufficient ventilation in the room where

the hood is installed, to allow simultaneous use of

other appliances that use gas or other fuels.

3.1 Assembly Instructions

Attention: Before proceeding with the installation,

make sure that the screws and the anchors already

supplied, are suitable for the type of wall the hood

must be fixed to.

To assemble the hood use the accessories that are

supplied and follow the instructions given in the

enclosed hand book.

Cut out dimensions

Aida 60

Fig 1

Fig 2