DuctSox OvalSox Руководство по установке - Страница 9

Просмотреть онлайн или скачать pdf Руководство по установке для Кабели и разъемы DuctSox OvalSox. DuctSox OvalSox 12 страниц.

™

DuctSox

OvalSox

Cable

Installation Manual

Step 4

Install DuctSox Fabric. DuctSox Inlet must be attached to the metal collar using screws

(not included) through plastic patches on the Inlet Belt. The screw fasteners are particularly

important when your inlet is oval or rectangular, but they should always be used. Be sure to

locate the zipper start and seam at the 12:00 orientation for proper alignment.

Twist and snap the Glider attachments of the DuctSox onto the cable (pliers may be helpful for

installation and removal of Gliders). Unzip fittings and slide them in place independently of the

straight sections. Cable Stops

are installed at the Endcap

Glider, at the Inlet Glider, and

at each Glider immediately

adjacent to all fittings. Leave

them installed loose until Step

5 is complete. Close all zipper

connections before moving to

Step 5.

Connect hanger rods to the

OvalSox. See illustration below. Connection of hanger rods to the OvalSox may be done prior to locking Glider attachments

onto the cable, if desired.

First slide the rod into the rope loops.

Then attach the rod clips to the rod and the webbing.

The Cable Stop is used to keep sections of DuctSox from moving lengthwise on the cable. They also are used to put a slight

tension on straight sections of DuctSox (straight sections may consist of more than one zippered section of DuctSox). Nuts are

tightened to lock the stop at locations where Gliders are to be locked in place (see Step 5).

Publication: AMEN00416 2021-02-22