DUDOFF CH-F2B Инструкции пользователя - Страница 7

Просмотреть онлайн или скачать pdf Инструкции пользователя для Варочная панель DUDOFF CH-F2B. DUDOFF CH-F2B 12 страниц. Vitroceramic hob

Печатать страницу

in accordance with the law and current

standards.

Incorrect installation may damage property

or cause harm to people or animals.

Follow below guidelines for built-in

appliance:

• The

supporting

heat-resistant up to a temperature of

approximately 100°C.

• If the appliance is to be installed above

an oven, the oven must have a forced

ventilation cooling system.

• Avoid installing the hob above a

dishwasher: if this cannot be avoided,

place a waterproof separation device

between the two appliances.

Failure to follow this precautions, could

cause a malfunction on the appliance.

POSITIONING

The domestic appliance was built in order

to be encased on a work surface, the

way it is illustrated in the graph (Fig.1).

Predispose sealing material (Fig.4) along

the whole perimeter (for dimensions of the

cut see Fig.1). This operation is necessary

to avoid any liquids penetrating the

worktop, as it is not possible to guarantee

that the top, the glass and their connection

are completely flat.

Lock the domestic appliance into place

with 4 supporters, keeping in mind the

width of the surface (Fig.2).

If the lower part of the appliance after

installation, is accessible via the lower

part of the furniture, it is necessary to

mount a separating panel keeping in mind

the distances indicated (Fig.3).

This is not necessary if underneath the

hob is installed an oven.

ELECTRICAL CONNECTIONS (Fig.6)

Before making the electrical connections,

check that:

- the ground wire is 2 cm longer than the

surface

must

other cables;

- the system ratings meet the ratings

indicated on the identification plate fixed

on the lower part of the worktop;

- the system is fitted with efficient ground

wires in accordance with the laws and

current standards.

WARNING! THIS APPLIANCE MUST

BE GROUNDED

The electrical safety of this appliance

can only be guaranteed when continuity

is complete between it and an effective

earthing

system,

with current local and national safety

regulations.

It is most important that this basic safety

requirement is present and regularly

tested and, where there is any doubt, the

electrical wiring in the home should be

inspected by a qualified electrician.

The manufacturer cannot be held liable

for the consequences of an inadequate

earthing system such as an electric shock.

The

manufacturer

liable for damage which is the direct or

indirect result of incorrect installation or

connection.

If the domestic appliance is not supplied

with a cable and/or suitable plug, use

material suitable for the absorption value

indicated on the identification plate and

the operating temperature.

If wishing to make a direct connection to

the mains, an omnipolar switch must be

installed with a minimum 3 mm opening

between the contacts and appropriate

for the load indicated on the plate and in

accordance with current standards (the

yellow/green ground conductor must not

be disconnected by a switch).

When the appliance has been installed,

the omnipolar switch must be easily

reachable.

which

complies

cannot

held