Duerkopp Adler 271 Руководство по эксплуатации - Страница 15

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Швейная машина Duerkopp Adler 271. Duerkopp Adler 271 18 страниц. Preface and general safety notes
Также для Duerkopp Adler 271: Инструкции по монтажу (2 страниц)

Печатать страницу

Duerkopp Adler 271 Руководство по эксплуатации

3.5 Regulating the Needle Thread Tension

3.6 Thread Regulator

Pre-tensioning for Thread Trimming

For the sure functioning of the thread trimming with

opened main tension 4 a small residual tension of the

needle thread is required.

This residual tension is achieved by pre-tensioning 3. At

the same time it influences the length of the cut needle

thread end. (Starting thread for the next seam.)

Short starting thread = tighten the knurled nut 3.

As base position applies:

Front of the knurled nut and bolt flush.

Greater adjustments of the pre-tensioning makes a

readjustment of the main tension necessary.

Main tension

Pre-tensioning 3 and main tension 4 should give the

recommended needle thread tension of e.g. 80g.

Set the main tension 4 accordingly.

With the thread regulator 6 the needle thread quantity

required for stitch building can be regulated. The setting

is dependent on stitch length, material thickness and

thread characteristics.

Note:

Only a precisely set thread regulator assures an optimal

sewing result.

The needle thread loop should glide over the hook

without excess and with little tension.

Loosen screw 9 and set the regulator accordingly.

The vertical wire 7 serves as a setting aid in conjunction

with the scale 8.